TNETX3150A datasheet(22/78 Pages) TI

22 / 78 page

TNETX15AE

ADDRESS-LOOKUP DEVICE

SPWS041A – AUGUST 1997 – REVISED OCTOBER 1997

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

management-table lookup interface at 0x0B–0x16 (DIO)

BYTE 3

BYTE 2

BYTE 1

BYTE 0

DIO ADDRESS

Findnode23–Findnode16

Findnode31–Findnode24

Findnode39–Findnode32

Findnode47–Findnode40

0x0C

Findport

Findnode7–Findnode0

Findnode15–Findnode8

0x10

Findcontrol

Findnodeage

0x14

The management-table lookup registers allow the management entity to find information about the node

addresses contained in the table.

These registers are part of the address lookup/inspection mechanism supported through the DIO (host)

interface. An address is fully described by the six bytes of findnode (0xC to 0x11). Data about an address is

returned in findport (0x12). FIND commands are issued through the findcontrol (0x16) register. They are

discussed later in more detail in numerical order.

To cause a FIND operation to execute, the host writes to the findcontrol register (0x16). To find the first address

in the table, execute a FIRST command. The target MAC address is returned in six bytes of findnode registers.

If a successive FIND command is executed (findnext), the starting point to continue the search is the six bytes

of findnode. The results are returned in the same registers, overwriting the original values. These registers can

be read/write between FINDS; a find next picks up with the current values of findnode. If a lookup on an address

to check parameters is executed, the data returned corresponds to the value in the six bytes of findnode when

the lookup command was given; the address parameters are posted in the findport register (0x12, 0x13). The

FIND operation completion is detected when the command bit is written back to 0 (poll). The find register block

is discussed later in further detail in numerical order.

lookup-node address register, findnode at 0x0C–0x11 (DIO)

The findnode registers are used to exchange addresses between the TNETX15AE and the management CPU.

The node address in findnode is kept in Ethernet native data format; bit 40 is the group/specific bit. The function

of findnode depends on the bits set in findcontrol:

D On FIRST operations, this register shows the first address in the lookup table. The data in findnode is valid

only when the FOUND bit in findcontrol is a 1.

D On NEXT operations, this register shows the next address in the lookup table. The data in findnode is valid

only when the FOUND bit in findcontrol is a 1.

D On LKUP operations, the lookup logic operation looks up the address stored in this register. If found, the

FOUND bit in findcontrol is set to a 1.

This register is readable/writeable. While any of the FIND command bits are set, writes to these addresses

are ignored.

TNETX3150A 数据表(PDF) 22 Page - Texas Instruments

TNETX3150A 数据表(HTML) 22 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78

数据表下载