AD9953_17 datasheet(28/32 Pages) AD

28 / 32 page

AD9953

Data Sheet

Rev. B | Page 28 of 32

When the CFR1<3> bit is 0 and the PWRDWNCTL input pin is

high, the AD9953 is put into a fast recovery power-down mode.

In this mode, the digital logic and the DAC digital logic are

powered down. The DAC bias circuitry, PLL, oscillator, and

clock input circuitry is not powered down.

When the CFR1<3> bit is high, and the PWRDWNCTL input

pin is high, the AD9953 is put into the full power-down mode.

In this mode, all functions are powered down. This includes the

DAC and PLL, which take a significant amount of time to

power up.

When the PWRDWNCTL input pin is high, the individual

power-down bits (CFR1<7>, <5:4>) are invalid (Don’t Care)

and unused. When the PWRDWNCTL input pin is low, the

individual power-down bits control the power-down modes of

operation.

Note that the power-down signals are all designed such that a

Logic 1 indicates the low power mode and a Logic 0 indicates

the active or power-up mode.

Table 10 indicates the logic level for each power-down bit that

drives out of the AD9953 core logic to the analog section and

the digital clock generation section of the chip for the external

power-down operation.

Layout Considerations

For the best performance, the following layout guidelines

should be observed. Always provide the analog power supply

(AVDD) and the digital power supply (DVDD) on separate

supplies, even if just from two different voltage regulators

driven by a common supply. Likewise, the ground connections

(AGND, DGND) should be kept separate as far back to the

source as possible (i.e., separate the ground planes on a

localized board even if the grounds connect to a common point

in the system). Bypass capacitors should be placed as close to

the device pin as possible. Usually a multitiered bypassing

scheme consisting of a small high frequency capacitor (100 pF)

placed close to the supply pin and progressively larger capaci-

tors (0.1 µF, 10 µF) placed further away from the actual supply

source works best.

Table 10. Power-Down Control Functions

Control

Mode Active

Description

PWRDWNCTL = 0 CFR1<3> Don’t Care

Software Control

Digital Power-Down = CFR1<7>

DAC Power-Down = CFR1<5>

Input Clock Power-Down = CFR1<4>

PWRDWNCTL = 1 CFR1<3> = 0

External Control,

Fast Recovery Power-Down Mode

Digital Power-Down = 1’b1

DAC Power-Down = 1’b0

Input Clock Power-Down = 1’b0

PWRDWNCTL = 1 CFR1<3> = 1

External Control,

Full Power-Down Mode

Digital Power-Down = 1’b1

DAC Power-Down = 1’b1

Input Clock Power-Down = 1’b1

AD9953 数据表(PDF) 28 Page - Analog Devices

AD9953 数据表(HTML) 28 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

数据表下载