IS25LP032D-RKLA3:P datasheet(86/118 Pages) ISSI

86 / 118 page

IS25LP032D

IS25WP032D

Integrated Silicon Solution, Inc.- www.issi.com

Rev. A12

08/04/2020

8.40 FAST READ DUAL IO DTR MODE OPERATION (FRDDTR, BDh)

The FRDDTR instruction enables Double Transfer Rate throughput on dual I/O of the device in read mode. The

address (interleave on dual I/O pins) is latched on both rising and falling edge of SCK, and the data (interleave on

dual I/O pins) shift out on both rising and falling edge of SCK at a maximum frequency. The 4-bit address can be

latched-in at one clock, and 4-bit data can be read out at one clock, which means two bits at the rising edge of

clock, the other two bits at the falling edge of clock.

The first address byte can be at any location. The address is automatically increased to the next higher address

after each byte of data is shifted out, so the whole memory can be read out with a single FRDDTR instruction. The

address counter rolls over to 0 when the highest address is reached. Once writing FRDDTR instruction, the

following address/dummy/data out will perform as 4-bit instead of previous 1-bit.

The sequence of issuing FRDDTR instruction is: CE# goes low  Sending FRDDTR instruction (1-bit per clock) 

24-bit address interleave on IO1 & IO0 (4-bit per clock)  4 dummy clocks (configurable, default is 4 clocks) on

IO1 & IO0  Data out interleave on IO1 & IO0 (4-bit per clock)  End FRDDTR operation via pulling CE# high at

any time during data out (Please refer to Figure 8.65 for 2 x I/O Double Transfer Rate Read Mode Timing Waveform).

If AXh (

where X is don’t care) is input for the mode bits during dummy cycles, the device will enter AX read operation

mode which enables subsequent FRDDTR execution skips command code. It saves cycles as described in Figure

8.66. When the code is different from AXh, the device exits the AX read operation. After finishing the read operation,

device becomes ready to receive a new command.

If the FRDDTR instruction is issued while a Program/Erase/Write Status Register cycle is in progress (WIP=1), the

instruction will be rejected without any effect on the current cycle.

IS25LP032D-RKLA3:P 数据表(PDF) 86 Page - Integrated Silicon Solution, Inc