User Manual

Please read the Important Notice and Warnings at the end of this document

Revision 1.4

www.infineon.com

page 1 of 47

2020-07-16

AN2019-04 EVAL-M3-IM564 User Manual

EVAL-M3-IM564 User Manual

iMOTION™ Modular Application Design Kit

About this document

Scope and purpose

This user manual provides an overview of the evaluation board EVAL-M3-IM564 including its main features, key

data, pin assignments and mechanical dimensions.

EVAL-M3-IM564 is an evaluation board as part of the iMOTION™ modular application design kit. This power

board includes a PFC integrated 3-phase CIPOS™ Mini intelligent power module (IPM) for motor drive

applications. In combination with the control board equipped with the M3 30-pin interface connector such as

EVAL-M3-102T, it features and demonstrates Infineon’s CIPOS™ Mini IPM technology and advanced motion

control engine (MCE 2.0) technology for permanent magnet motors drive over the full speed range.

The inverter section has 600 V of voltage and 20 A of current rating, and the PFC section has 600 V of voltage and

20 A of current rating. It is optimized to major home appliances like air conditioners and low power motor dirve

applications with high-frequency switching operation of power factor correction.

This evaluation board EVAL-M3-IM564 was developed to support customers during their first steps designing

applications with CIPOS™ Mini PFC integrated IPM IM564-X6D/IM564-X6DS and running any permanent magnet

motor via sensorless sinusoidal control.

Intended audience

This user manual is intended for all technical specialists who know motor control and high-power electronics

converters. The board is intended to be used under laboratory conditions.

Attention:

The Evaluation Boards and Reference Boards as well as the information in this document are

solely intended to support designers of applications in evaluating the use of products from

Infineon Technologies for their intended applications.

Environmental conditions have been considered in the design of the Evaluation Boards and

Reference Boards provided by Infineon Technologies. The design of the Evaluation Boards

and Reference Boards has been tested by Infineon Technologies only as described in this

document. The design is not qualified in terms of safety requirements, manufacturing and

operation over the entire operating temperature range or lifetime.

The Evaluation Boards and Reference Boards provided by Infineon Technologies are subject

to functional testing only under typical load conditions. Evaluation Boards and Reference

Boards are not subject to the same procedures as regular products regarding returned

material analysis (RMA), process change notification (PCN) and product discontinuation (PD).

Evaluation Boards and Reference Boards are not commercialized products, and are solely

intended for evaluation and testing purposes. In particular, they shall not be used for

reliability testing or production. The Evaluation Boards and Reference Boards may therefore

not comply with CE or similar standards (including but not limited to the EMC Directive

2004/EC/108 and the EMC Act) and may not fulfill other requirements of the country in which

they are operated by the customer. The customer shall ensure that all Evaluation Boards and