BAV20WS-TP datasheet(14/47 Pages) INFINEON

14 / 47 page

User Manual

14 of 47

Revision 1.4

2020-07-16

EVAL-M3-IM564 User Manual

iMOTION™ Modular Application Design Kit

Getting started with EVAL-M3-IM564

1. Connect PC-USB connector on the on-board debugger to the PC via USB cable.

2. Connect EVAL-M3-IM564’s MADK M3 30-pin interface connector (J3) to control board (see Figure 4).

3. Get the latest “IMC102T-F064 MCE Software Package” available on www.infineon.com/imotion-software

website. (Infineon iMOTION™ control IC IMC102T-F064 is used for control board EVAL-M3-102T).

4. Connect motor phase outputs to the motor.

5. Use MCEWizard to enter the motor and evaluation board hardware parameters, and click button “Export to

Designer file (.txt)” to system drive parameters’ file which will be used by MCEDesigner.

6. Connect AC power to power input connector (J1) and power-on system.

7. Open MCEDesigner and open MCEDesigner default configuration file (.irc) for IMC102T devices

(IMC102T_xx.irc) by clicking “File” menu and select “Open” in the pull down list.

8. Import system drive parameters’ file (generated in step 5) into MCEDesigner by clicking “File” > “Import

Drive Parameters.” Select “Update All” radio button.

9. Program the MCE firmware and system parameters into the internal flash memory of iMOTION™ IC by

clicking “Tools > Programmer “in the pull-down menu, and then clicking on the “Program Firmware and

Parameter” radio button. See the chapter “MCEDesigner setup overview” in Section 3.2.2 for more details. If

the latest version of MCE firmware is already programmed into the IMC102T-F064 IC, then programming

firmware can be skipped by selecting “Program Parameters” radio button option. Finally click “Start”

button to program firmware and parameters (or parameters only when programming firmware was

skipped).

10. Start the motor by clicking the green traffic light button in the control bar.

BAV20WS-TP 数据表(PDF) 14 Page - Infineon Technologies AG