6

Electrical characteristics

This section summarizes the operating and measurement conditions, and the DC and AC characteristics of the

device. The parameters in the DC and AC characteristic tables that follow are derived from tests performed under

the measurement conditions summarized in the relevant tables. Users should check that the operating conditions

in their circuit match the measurement conditions when relying on the quoted parameters.

6.1

Absolute maximum ratings

Table 1. Absolute maximum ratings

Symbol

Parameter

Value

Unit

VCC

Supply voltage

–0.3 to 6.5

V

VIO

Input or output voltage relative to ground

–0.3 to VCC +0.3

V

TA

Ambient operating temperature

–40 to +105

°C

TSTG

Storage temperature (Please refer to package specification)

–65 to +150

°C

TLEAD

Lead temperature during soldering

See (1)

°C

VESD

Electrostatic discharge voltage according to JESD22-A114, Human Body Model

4000

V

1. Compliant with JEDEC standard J-STD-020D (for small-body, Sn-Pb or Pb-free assembly), the ST ECOPACK® 7191395

specification, and the European directive on Restrictions on Hazardous Substances (RoHS directive 2011/65/EU of July

2011).

Note:

Stresses listed above may cause permanent damage to the device. This is a stress rating only and functional

operation of the device at these or any other conditions above those indicated in the operational sections of the

specification is not implied.

Exposure to absolute maximum rating conditions for extended periods may affect device reliability.

6.2

Recommended power supply filtering

As mentioned in Section 7.1.2 Pinout information, the power supply of the circuit must be filtered using the circuit

shown in the following figure.

Figure 6. Recommended filtering capacitors on VCC

Interface device

I/O

CLK

RST

Vcc

GND

100 nF

1 µF

+

-

ST4SIM-200M

Electrical characteristics

DB4082 - Rev 5

page 10/26