| 数据搜索系统,热门电子元器件搜索 |
|
R2000 数据表(PDF) 24 Page - List of Unclassifed Manufacturers |
|
|
|||||||||||||||||||||||||||||
R2000 数据表(HTML) 24 Page - List of Unclassifed Manufacturers |
|
24 / 75 page ![]() Indy® R2000 Electrical, Mechanical, & Thermal Specification Revision 2.0, Copyright © 2015, Impinj, Inc. 24 Figure 4-10: Detailed TX to RX (Self Jammer) Path Block Diagram 11 dB pad 1 dBm 31 dBm +30 dB PA Indy Reader Chip TX LO -10 dB 10 dB return loss -1 dB 30 dBm 10 dBm 20 dBm PA Self Jammer Path LO Path RX Balun and matching + - + - + - 0/90 10 dB coupler Balun and matching Balun and matching 6 dB SAW filter/Pad 7 dBm -6 dB KEY: 5.3.2 TX to LO (Self Jammer Cancellation) Path The TX to LO or “Self Jammer Cancellation” path is the path taken by the transmitted high power signal that is coupled through the directional coupler towards the reader’s LO port. Example losses and gains of this signal along the path are shown in Figure 4-11. These values are approximately based on the configuration used in the R2000 development kit and reference design. The path gains and losses are described below. The gains and losses are the same as the TX to RX path until the signal hits the directional coupler. 1. The TX signal exits the Indy Reader chip’s differential TX pins at the user specified power level. 2. The signal passes through the TX balun and matching network, with a certain amount of loss, for a power level of 7 dBm. 3. The signal passes through the SAW filter or pad (depending on configuration), attenuated by 6 dB, for a power level of 1 dBm. 4. The signal is amplified by 30 dB by the external PA, for a power level of 31 dBm. 5. The signal passes through the directional coupler to the coupled port, with an attenuation of 10 dB, for a power level of 21 dBm. 6. The signal is attenuated by 11 dB by the pad, for a power level of 10 dBm. a. This attenuation is selected such that the amplitude of the LO signal will be equal to the maximum expected self jammer signal at the RX port, as described in section 5.1.5. 7. The 10 dBm signal passes through the balun and matching network, again with the balun’s characteristic loss, and enters the Indy reader chip’s differential LO port. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |