M700000002 datasheet(19/128 Pages) SPANSION

19 / 128 page

November 25, 2003

Am70PDL127BDH/Am70PDL129BDH

AD VAN C E

INFORM ATION

RESET#: Hardware Reset Pin

The RESET# pin provides a hardware method of re-

setting the device to reading array data. When the RE-

SET# pin is driven low for at least a period of t

RP, the

device immediately terminates any operation in

progress, tristates all output pins, and ignores all

read/write commands for the duration of the RESET#

pulse. The device also resets the internal state ma-

chine to reading array data. The operation that was in-

terrupted should be reinitiated once the device is

ready to accept another command sequence, to en-

sure data integrity.

Current is reduced for the duration of the RESET#

pulse. When RESET# is held at V

SS±0.3 V, the device

draws CMOS standby current (ICC4). If RESET# is

held at V

IL but not within VSS±0.3 V, the standby cur-

rent will be greater.

The RESET# pin may be tied to the system reset cir-

cuitry. A system reset would thus also reset the Flash

memory, enabling the system to read the boot-up firm-

ware from the Flash memory.

If RESET# is asserted during a program or erase op-

eration, the RY/BY# pin remains a “0” (busy) until the

internal reset operation is complete, which requires a

time of t

READY (during Embedded Algorithms). The sys-

tem can thus monitor RY/BY# to determine whether

the reset operation is complete. If RESET# is asserted

when a program or erase operation is not executing

(RY/BY# pin is “1”), the reset operation is completed

within a time of t

READY (not during Embedded Algo-

rithms). The system can read data t

RH after the RE-

SET# pin returns to V

IH.

Refer to the pSRAM AC Characteristics tables for RE-

SET# parameters and to Figure 11 for the timing dia-

gram.

Output Disable Mode

When the OE# input is at V

IH, output from the device is

disabled. The output pins (except for RY/BY#) are

placed in the highest Impedance state

Table 5.

SecSi

TM Sector Addresses

Sector Size

Address Range

Am29PDL127H/

Am29PDL129H

128 words

000000h–00007Fh

Factory-Locked Area

64 words

000000h-00003Fh

Customer-Lockable Area

64 words

000040h-00007Fh

M700000002 数据表(PDF) 19 Page - SPANSION

M700000002 数据表(HTML) 19 Page - SPANSION

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载