Type SE35 + S077

4 | 20

Visit product website 

1.

General technical data

1.1. About the device

The device Type SE35 + S077 is available as a Inline flowmeter or a batch controller in a compact variant.

1.2. All variants

The following data are valid for both the Inline flowmeter and the batch controller.

Product properties

Material

Make sure the device materials are compatible with the fluid you are using.

Further information can be found in chapter “4.1. Bürkert resistApp” on page 9.

Further information on the materials can be found in chapter “4.2. Material specifications” on page 10.

Non wetted parts

Lid

PC

Front panel film

Polyester

Cover

PC

Housing

PC

Screw

Stainless steel

Bayonet system

PC

Cable gland

PA

Wetted parts

Axis

Stainless steel 316L (1.4401)

Oval gear

Stainless steel 316L (1.4401)

Sensor-fitting body

Aluminium, stainless steel 316L (1.4401)

Cover

Aluminium, stainless steel 316L (1.4401)

Seal

FKM or FEP/PTFE encapsulated

Display

15 × 60 mm, 8-digit LCD, alphanumeric,15 segments, 9 mm high

Compatibility

Any pipe from DN 15…DN 100 which is fitted with Bürkert S077 Inline sensor-fitting.

For the selection of the nominal diameter of the Inline sensor-fittings, see data sheet Type S077 .

Pipe diameter

DN 15…DN 100

Dimensions

Further information can be found in chapter “5. Dimensions” on page 11.

Measuring principle

Oval gear

Measuring range

• Viscosity > 5 mPa.s: 2…1200 l/min (0.53…320 gpm)

• Viscosity < 5 mPa.s: 3…616 l/min (0.78…320 gpm)

Performance data

Measurement deviation

• Teach-in or specific K factor, engraved on the Inline sensor-fitting: ± 0.5 % of the measured value at

Teach-In flow rate value

• Standard K factor: ± 1 % of the measured value

Repeatability

± 0.03 % of the measured value 1.)

Electrical data

Power source (not supplied)

Limited power source according to UL/EN 62368-1 standards or limited energy circuit according to UL/

EN 61010-1 paragraph 9.4

Protection against DC polarity

reversal

Yes

Overvoltage protection

Yes

Voltage supply cable

• Cable with maximum operating temperature greater than 80 °C (176 °F) (90 °C (194 °F) for UL

Recognized variant)

• Max. 50 m length, shielded