Type SE35 + S077

5 | 20

Visit product website 

Medium data

Fluid temperature

With Inline sensor-fitting Type S077 in:

• Aluminium: - 20…+ 80 °C (- 4…+ 176 °F)

• Stainless steel: - 20…+ 120 °C (- 4…+ 248 °F)

See data sheet Type S077  for more information.

Fluid pressure

With Inline sensor-fitting Type S077 with:

• DN 15: max. 55 bar (798.05 PSI) (threaded process connection)

• DN 25: max. 55 bar (798.05 PSI) 1.)

• DN 40 or DN 50: max. 18 bar (261.18 PSI)

• DN 80: max. 12 bar (174.12 PSI)

• DN 100: max. 10 bar (145.1 PSI)

See data sheet Type S077  for more information.

Viscosity

Max. 1 Pa.s (higher on request)

Rate of solid particles

0 %

Process/Pipe connection & communication

Pipe connection

With Inline sensor-fitting Type S077 with:

• Thread: ½", 1", 1½", 2" or 3" (G or NPT)

• Flange:

– 25, 40, 50, 80 or 100 mm DIN PN 16 flange

– 1", 1½", 2", 3" or 4" ANSI 150LB flange

See data sheet Type S077  for more information.

Approvals and conformities

Directives

CE directive

Further information on the CE Directive can be found in chapter “3.3. Standards” on page 9.

Pressure equipment directive

Complying with article 4, paragraph 1 of 2014/68/EU directive

Further information on the pressure equipment directive can be found in chapter “3.4. Pressure

Equipment Directive (PED)” on page 9.

North America (USA/Canada)

UL Recognized for the USA and Canada

Environment and installation

Relative air humidity

≤ 80 %, without condensation

Height above sea level

Max. 2000 m

Operating condition

Continuous

Equipment mobility

Fixed

Application range

Indoor and outdoor

Protect the device against electromagnetic interference, ultraviolet rays and, when installed outdoors,

against the effects of climatic conditions.

Degree of protection 2.) according

to IEC/EN 60529

IP65 with the following conditions met:

• device wired

• cover and lid screwed tight

• female cable plug or glands mounted and tightened

• with blind plug on unused cable glands

Installation category

Category I according to UL/EN 61010-1

Pollution degree

Degree 2 according to UL/EN 61010-1

1.) Or in accordance to the value of the used flanges

2.) Not evaluated by UL