Type SE35 + S077

17 | 20

Visit product website 

7.3. Function modes

Flowmeter with standard output signal

• 4…20 mA output + Pulse

• 4…20 mA output + Pulse + relay output

Hysteresis switching mode (both relays) for the output, inverted or not

OLO

OHI

OLO

OHI

Contact

inverted

not inverted

Contact

Hysteresis mode

Batch controller

The following dosing modes are possible:

• Locally started dosing of

– free quantity: the user enters the quantity to be filled and starts the dosing from the keypad.

– pre‑set quantity: the user selects a quantity which has been pre-set and starts the dosing from the keypad.

• Dosing controlled by a PLC unit: the user selects a quantity which has been pre-set and starts the dosing using binary inputs.

• Locally/remote selection of pre‑set quantity and dosing controlled by a PLC unit: the user selects a quantity which has been pre-set

from the keypad or using binary inputs and starts the dosing using binary inputs.

• Automatic dosing controlled by variation of pulse duration: the volume to be dosed is directly proportional to the duration of a pulse.

• Locally/remote dosing determined by teach-in:

– teach-in of the dosing quantity from the keypads

– teach-in of the dosing quantity using binary inputs.

8.

Product design and assembly

8.1. Product assembly

Note:

• The device Type SE35 + S077 is made up of a Bürkert Inline sensor-fitting Type S077 equipped with a sensor with oval gears and a

transmitter Type SE35.

• The Inline sensor-fitting Type S077 ensures simple installation into pipes from DN 15…DN 100. The transmitter Type SE35 can be

mounted on any Inline sensor-fitting Type S077 and fastened with a bayonet catch, see data sheet Type S077  for more information.

Inline

sensor-fitting

Type S077

Transmitter

Type SE35

Inline measurement device

Type SE35 + S077

for flow measurement

or batch control