Type SE35 + S077

14 | 20

Visit product website 

7.2. Functional overview

Display and operating keys

The display is used to:

• read the value of certain parameters e.g. for the flowmeter, the measured flow rate, the main totalizer

• set parameters of the device by means of 3 keys

• read the configuration of the device

• be warned of certain events.

Display and operating keys

No. Description

1

5

3

6

2

4

1

“Back” key:

• to change the value (0…9) of the selected digit

• to go back to the previous function

• Read the batches history (only for batch controller)

2

“Next” key:

• to select the digit at the left

• to go to the next function

• read messages (only with Inline flowmeter as battery powered indicator/totalizer and with

batch controller)

3

“Confirm” key:

• to confirm the function displayed

• to confirm the parameters set

4

• For Inline flowmeter with a standard output signal

– status LED of relay 2

• For batch controller

– status LED of relay DO3 (LED ON = contact closed)

5

• For Inline flowmeter with a standard output signal

– status LED of relay 1

• For batch controller

– status LED of relay DO2 (LED ON = contact closed)

6

Status of device

• No status for Inline flowmeter with a standard output signal

• For Inline flowmeter as a battery powered indicator/totalizer

– off: the device operates correctly.

– blinking orange: a warning message is generated in the information menu.

– blinking red: a fault message is generated

• For batch controller

– green: the device operates correctly.

– orange: a dosing related alarm and/or a warning messages is generated in the information

menu.

– red: a fault message is generated in the information menu..

– blinking, whatever the colour:

- slow blinking: the dosing is interrupted.

- Fast blinking during a dosing: a dosing related alarm is generated.

- Fast blinking when no dosing is being done: the information menu has been remote-con-

sulted or a check for the correct behaviour of the inputs/outputs is running

The device can be calibrated by means of the K factor of the fitting or via the teach function. User adjustments, such as engineering units,

output, filter or bargraph are carried out on site.