BMP581 datasheet(16/75 Pages) BOSCH

16 / 75 page

Bosch Sensortec | BST-BMP581-DS004-11

16 | 75

Document number: BST-BMP581-DS004-11

as well as in the event of applications for industrial property rights

4.3 Power modes

The power modes of BMP581 and transitions in between are depicted in Figure 2. After startup or soft-reset, the BMP581

will be in DEEP STANDBY mode. Transitions from one mode to another are only possible by entering SLEEP mode first.

Figure 2: Power modes diagram

4.3.1 STANDBY mode

In STANDBY mode, no measurements are performed and power consumption is at a minimum. All registers are

accessible for write and read. Mode transitions to other modes are possible. The pressure and temperature data

registers PRESS_DATA_XXX and TEMP_DATA_XXX keep the values of the last measurement executed. The FIFO. if

enabled, also maintains it‘s content and can be read.

4.3.2 DEEP STANDBY

In order to further reduce the power consumption further, the BMP581 offers a DEEP_STANDBY mode. In this case,

power consumption is even lower than in STANDBY mode.

DEEP_STANDBY will only be entered if also the following conditions apply:



ODR_CONFIG.deep_dis = 0



ODR_CONFIG.odr < 5Hz



FIFO_SEL.fifo_frame_sel = DIS



DSP_IIR.set_iir_t = BYPASS



DSP_IIR.set_iir_p = BYPASS

If one of these settings is changed, the BMP581 transitions to STANDBY mode.

4.3.3 FORCED mode

In FORCED mode, a single measurement is performed according to selected measurement and filter options. When

the measurement is finished, the sensor returns to sleep mode and the measurement results can be obtained from the

data registers. For a next measurement, forced mode needs to be selected again. Forced mode is recommended for

applications which require very low sampling rate or host-based synchronization. Forced mode may also be used if an

ODR higher than 240 Hz is needed.

BMP581 数据表(PDF) 16 Page - Bosch Sensortec GmbH