CBLUSB01 datasheet(10/36 Pages) REDLION

10 / 36 page

PAXT Jumper Selection

Main

Circuit

Board

JUMPER

LOCATION

JUMPER

LOCATION

USER INPUT

RTD

INPUT

USER INPUT LOGIC JUMPER

SINK

SOURCE

RTD INPUT JUMPER

REAR TERMINALS

10 ohms

100 ohms

JUMPER SELECTIONS

The

indicates factory setting.

RTD Input Jumper

One jumper is used for RTD input ranges. Select the proper range to match

the RTD probe being used. It is not necessary to remove this jumper when

not using RTD probes.

The plug-in cards are separately purchased optional cards that perform

specific functions. These cards plug into the main circuit board of the meter. The

plug-in cards have many unique functions when used with the PAX.

CAUTION: The plug-in card and main circuit board contain static

sensitive components. Before handling the cards, discharge static

charges from your body by touching a grounded bare metal

object. Ideally, handle the cards at a static controlled clean

workstation. Also, only handle the cards by the edges. Dirt, oil or

other contaminants that may contact the cards can adversely

affect circuit operation.

To Install:

1. With the meter removed from the case, locate the plug-in card connector for

the card type to be installed. The types are keyed by position with different

main circuit board connector locations. When installing the card, hold the

meter by the rear terminals and not by the front display board.

If installing the Quad sourcing Plug-in Card (PAXCDS40), set the jumper for

internal or external supply operation before continuing.

2. Install the plug-in card by aligning the card terminals with the slot bay in the

rear cover. Be sure the connector is fully engaged and the tab on the plug-in

card rests in the alignment slot on the display board.

3. Slide the meter base back into the case. Be sure the rear cover latches fully

into the case.

4. Apply the plug-in card label to the bottom side of the meter in the designated

area. Do Not Cover the vents on the top surface of the meter. The surface of

the case must be clean for the label to adhere properly.

Internal Supply

(18 V unregulated)

External Supply

(30 V

)

max

3.0 insTalling plUg-in Cards

Finger

Tab

Finger

Tab

Serial

Communications

Card

Setpoint

Output

Card

Alignment

Slots

Connectors

Analog Output

Card

Main

Circuit

Board

TOP VIEW

CBLUSB01 数据表(PDF) 10 Page - Red Lion Controls. Inc

CBLUSB01 数据表(HTML) 10 Page - Red Lion Controls. Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

数据表下载

链接网址

CBLUSB01 数据表(PDF) 10 Page - Red Lion Controls. Inc

CBLUSB01 数据表(HTML) 10 Page - Red Lion Controls. Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

数据表 下载

链接网址

数据表下载