11. ELECTRICAL SPECIFICATION

11.1 DC electrical characteristics

ABSOLUTE MAXIMUM RATINGS

Symbol

Parameter

Min.

Typ.

Max.

Units

Notes (1,2)

DC supply voltage

0

7.0

V

3

Voltage on any other pin

-1.0

V

3

Temperature under bias

-40

85

°C

Storage temperature

-65

150

°C

PDmax

Power dissipation

2.0

W

Notes : 1. All voltages are with respect to GND.

2. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the

operational sections of this specification is not implied. Stresses greater than those listed may cause permanent damage to the

device. Exposure to absolute maximum rating conditions for extended periods may affect reliability.

3. This device contains circuitry to protect the inputs against damage caused by high static voltages or electrical fields. However,

it is advised that normal precautions be taken to avoid application of any voltage higher than the absolute maximum rated

DC OPERATING CONDITIONS

Symbol

Parameter

Min.

Typ.

Max.

Units

Notes (1)

Supply Voltage

4.5

5.0

5.5

V

Input Logic ‘1’ Voltage CLK

Input Logic ‘1’ Voltage other pins

4.0

2.0

V

V

2

2

Input Logic ‘0’ Voltage CLK

Input Logic ‘0’ Voltage other pins

-0.5

-0.5

0.5

0.8

V

V

2

2

TA

Ambient Operating Temperature

0

70

°C

3

Notes : 1. All voltages are with respect to GND.

2. Input signal transients, up to 10ns wide, are permitted in the voltage ranges (GND - 0.5V) to (GND - 1.0V)

3. 400 linear ft/min transverse air flow.

DC CHARACTERISTICS

Symbol

Parameter

Min.

Typ.

Max.

Units

Notes (1,2)

Output Logic ‘1’ Voltage

2.4

V4

Output Logic ‘0’ Voltage

0

0.4

V

5

Input leakage current(any input current)

± 10

µA

3

Off state output leakage current

± 10

µA

3

Average power supply current

350

mA

Notes : 1. All voltages are with respect to GND.

2. Parameters measured over full voltage and temperature operating range.

4. IOut

≤ -4.4 mA

5. IOut

≤ 4.4 mA

CAPACITANCE

Pin

Min.

Typ.

Max.

Units

Notes

CLK

12

pF

1,2

All other pins

5

pF

1,2

Notes : 1. This parameter is supplied for engineering guidance and is not guaranteed.

2. TA= 25°C , F= 1 MHz.

IMSA110

21/26