Parallel (with MSO option)

Trigger on a parallel bus data value. Parallel bus can be from 1 to 20 bits (from the digital and analog channels)

in size. Supports binary and hex radices

I2C (option)

Trigger on start, repeated start, stop, missing ack, address (7 or 10 bit), data, or address and data on I2C buses

up to 10 Mb/s

SPI (option)

Trigger on slave select, idle time, or data (1-16 words) on SPI buses up to 20 Mb/s

RS-232/422/485/UART (option)

Trigger on start bit, end of packet, data, and parity error up to 15 Mb/s

CAN (option)

Trigger on start of frame, type of frame (data, remote, error, or overload), identifier, data, identifier and data, end

of frame, missing ack, and bit stuff error on CAN buses up to 1 Mb/s

LIN (option)

Trigger on sync, identifier, data, identifier and data, wakeup frame, sleep frame, and error on lin buses up to 1

Mb/s

SENT (option)

Trigger on start of packet, fast channel status and data, slow channel message ID and data, and CRC errors

Acquisition system modes

Sample

Acquired sample values

Peak Detect

Highest and the lowest sample within the decimation interval

Averaging

Average of a series of acquired waveforms up to 10,240 acquisitions

Envelope

Min-Max envelope over multiple acquisitions

Hi-Res

Applies a unique bandwidth filter for each sample rate that maintains the maximum bandwidth possible for that

sample rate while preventing aliasing and removing noise from the oscilloscope amplifiers and ADC above the

usable bandwidth for the selected sample rate.

Waveform measurements

Cursors

Waveform, V bars, H bars, and V&H bars

Automatic measurements

36, of which an unlimited number can be displayed as either individual measurement badges or collectively in a

measurement results table

Amplitude measurements

Amplitude, maximum, minimum, peak-to-peak, positive overshoot, negative overshoot, mean, RMS, AC RMS,

top, base, and area

Time measurements

Period, frequency, unit interval, data rate, positive pulse width, negative pulse width, skew, delay, rise time, fall

time, phase, rising slew rate, falling slew rate, burst width, positive duty cycle, negative duty cycle, time outside

level, setup time, hold time, duration n-periods, high time, and low time, time to max, and time to min

Measurement statistics

Mean, standard deviation, maximum, minimum, and population. Statistics are available on both the current

acquisition and all acquisitions

2 Series MSO Datasheet

www.tek.com 17