22

System

pro M compact ®

Residual-current-operated circuit-breakers

F 200 series/FS 201

Installation and operation instructions

Installation

Can be installed in any mounting position due to snap-on fixing to DIN rails EN 50 022, 35 mm width.

A If RCD F 200/FS 201 is installed without cross-wiring , hinge the upper part into the DIN rail and push to let the lower part of the device snap

into place (1). The device is released in the reverse order, after the quick fastener has been removed with a screw driver (2).

B To release RCD F 200/FS 201 that are cross-wired with System pro M compact busbars, first remove the clamping screws. Then, pull the

lower part of the F 200/FS 201 forwards (1) and lift it straight up (1a), then, the quick fastener will recede (1b).

C The busbar is deallocated and the RCD F 200/FS 201 can be pulled out by lifting the device forwards (2).

D The cross-wiring is re-inserted in the reverse order. First, open the clamping screws and pull out the quick fastener until it locks into place

for the first time (3). Then, take the RCD F 200/FS 201 and insert it with the rear terminal side onto the pins of the System pro M compact

busbar (4), turn it into the direction of the DIN rail (4a) and shift it vertically downwards (4b), to let the quick fastener snap back into place

(4c).

Attention: Do not forget to re-tighten the clamping screws.

Connection

Feeder optional, top or bottom. Ensure that conductors are con-

nected correctly and firmly.

If the 4-pole RCCB is operated as a 2-pole RCCB, use terminals

5 and 7 or, as the case may be, 6 and 8 to make sure that the

test button function of the RCCB is working. In the case of a

three-phase system with Un = 127/230 V (without neutral N),

terminals 4 and 8 must be bridged.

Operation

F 200/FS 201 is switched ON or OFF with the blue operating

lever.

C Removal when

pro M compact

cross wiring

remains in place

pro M compact

busbar

pro M compact

busbar

quick

fastener

D Insertion when

pro M compact

cross wiring

remains in place

A Assembly,

disassembly

without

pro M compact

cross wiring

B Detaching when

pro M compact

cross wiring

remains in place

snap on

release

pro M compact

busbar

pin

pin

Operating test

To test proper functioning, press the blue test button when the device is switched ON, the RCCB must trip immediately (the knob jumps into

the „0“ switching position).

It is necessary to test the RCD halfyearly, if no other regional or user specified additional test are required.