24

System

pro M compact ®

Load capability depending on the feed point

bar cross section

10 mm2

16 mm2

max. busbar current IS/phase

63 A

80 A

max. current in branch IE/phase

100 A

130 A*

* If the device is fed via the device terminal, ensure that - irrespective of the current carrying capacity (I

S) of the busbar -

the following values are not exceeded:

For devices up to and including 40 A I

n max. 110 A and for 50/63 A In max. 140 A.

Description

The newly developed pro M compact cross wiring busbar system includes everything that is needed for secure and economic connections

of distribution build-in devices of the series S 200 and F 200.

The optimised quick fastener of the S 200 series, F 200 , when used together with the System pro M compact cross wiring busbars, makes

removing and inserting devices a quick and easy job, and the cross wiring of other devices remains in place, at that.

Busbars are supplied ready-to-use and in standard lengths, time-consuming cutting to length or end caps are no longer required.

MCBs and RCCBs of the customary System pro M technology can also be easily cross-wired with the new System pro M compact busbars.

Technical data

specifications:

VDE 0660 Part 500, DIN EN 60439-1: 1994 test surge voltage: (1,2/50)

6,2 kV

busbar material:

SF-Cu F 24

short-circuit withstand capacity: 25 kA

insulating profile material:

plastic, temperature resistant

90 °C

climatic resistance:

constant climate L23/83; 40/92

flame-retardant, self-extinguishing

55/20 according to DIN 50 015

dioxine- and halogene-free

humid heat, 28 cycles

(

IEC 68 Part 2 - 30)

busbar cross section:

10 mm2

insulation coordination:

acc. to VDE 0110 Part 1

April 1997 (IEC 664)

max. operating voltage:

440 V

- overvoltage category:

III

rated surge voltage:

4 kV

- pollution degree:

2

incoming supply

incoming supply

at the beginning of the

within the busbar

busbar

or centre-fed

If the device is centre-fed (see picture to the right), ensure that the combined outgoing currents a1 ...an per branch do not exceed the max. busbar

current IS/phase referred to above.

Busbars for

series S 200, S 200 M, F 200, FS 201