L6566ATR datasheet(22/51 Pages) STMICROELECTRONICS

22 / 51 page

Application information

L6566A

22/51

Note:

When the system operates in valley skipping-mode, uneven switching cycles may be

observed under some line/load conditions, due to the fact that the OFF-time of the MOSFET

is allowed to change with discrete steps of one ringing cycle, while the OFF-time needed for

cycle-by-cycle energy balance may fall in between. Thus one or more longer switching

cycles will be compensated by one or more shorter cycles and vice versa. However, this

mechanism is absolutely normal and there is no appreciable effect on the performance of

the converter or on its output voltage.

If the MOSFET is enabled to turn on but the amplitude of the signal on the ZCD pin is

smaller than the arming threshold for some reason (e.g. a heavy damping of drain

oscillations, like in some single-stage PFC topologies, or when a turn-off snubber is used),

MOSFET’s turn-on cannot be triggered. This case is identical to what happens at start-up:

at the end of the next oscillator cycle the MOSFET will be turned on, and a new switching

cycle will take place after skipping no more than one oscillator cycle.

The operation described so far does not consider the blanking time TBLANK after MOSFET’s

turn off, and actually TBLANK does not come into play as long as the following condition is

met:

Equation 3

where D is the MOSFET duty cycle. If this condition is not met, things do not change

substantially: the time during which MOSFET’s turn-on is inhibited is extended beyond Tosc

by a fraction of TBLANK. As a consequence, the maximum switching frequency will be a little

lower than the programmed value fosc and valley-skipping mode may take place slightly

earlier than expected. However this is quite unusual: setting fosc = 150 kHz, the

phenomenon can be observed at duty cycles higher than 60 %. See Section 5.11: OVP

block on page 35

for further implications of TBLANK.

If the voltage on the COMP pin (9) saturates high, which reveals an open control loop, an

internal pull-up keeps the ZCD pin close to 2 V during MOSFET's OFF-time to prevent noise

from false triggering the detection block. When this pull-up is active, the ZCD pin might not

be able to go below the triggering threshold, which would stop the converter. To allow auto-

restart operation, however ensuring minimum operating frequency in these conditions, the

oscillator frequency that retriggers MOSFET's turn-on is that of the external oscillator

divided by 128. Additionally, to prevent malfunction at converter's start-up, the pull-up is

disabled during the initial soft-start (see the relevant section). However, to ensure a correct

start-up, at the end of the soft-start phase the output voltage of the converter must meet the

condition:

Equation 4

where Ns is the turn number of the secondary winding, Naux the turn number of the

auxiliary winding and IZCD the maximum pull-up current (130 µA).

osc

BLANK

−

≤

ZCD

Z I

Naux

Vout

L6566ATR 数据表(PDF) 22 Page - STMicroelectronics

L6566ATR 数据表(HTML) 22 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51

数据表下载