AD9520-3SLASHPCBZ datasheet(15/84 Pages) AD

15 / 84 page

AD9520-3

Rev. 0 | Page 15 of 84

PD, SYNC, AND RESET PINS

Table 15.

Parameter

Min

Typ

Max

Unit

Test Conditions/Comments

INPUT CHARACTERISTICS

These pins each have a 30 kΩ internal pull-up resistor

Logic 1 Voltage

2.0

Logic 0 Voltage

0.8

Logic 1 Current

μA

Logic 0 Current

−110

μA

The minus sign indicates that current is flowing out of

the AD9520, which is due to the internal pull-up resistor

Capacitance

RESET TIMING

Pulse Width Low

RESET Inactive to Start of Register Programming

100

SYNC TIMING

Pulse Width Low

1.3

High speed clock is CLK input signal

SERIAL PORT SETUP PINS: SP1, SP0

Table 16.

Parameter

Min

Typ

Max

Unit

Test Conditions/Comments

SP1, SP0

These pins do not have internal pull-up/pull-down resistors

Logic Level 0

0.25 × VS

VS is the voltage on the VS pin

Logic Level ½

0.4 × VS

0.65 × VS

User can float these pins to obtain Logic Level ½; if floating this pin, user

should connect a capacitor to ground

Logic Level 1

0.8 × VS

LD, STATUS, AND REFMON PINS

Table 17.

Parameter

Min

Typ

Max

Unit

Test Conditions/Comments

OUTPUT CHARACTERISTICS

When selected as a digital output (CMOS); there are other

modes in which these pins are not CMOS digital outputs;

see Table 53, 0x017, 0x01A, and 0x01B

Output Voltage High, VOH

2.7

Output Voltage Low, VOL

0.4

MAXIMUM TOGGLE RATE

100

MHz

Applies when mux is set to any divider or counter output,

or PFD up/down pulse; also applies in analog lock detect

mode; usually debug mode only; beware that spurs can

couple to output when any of these pins are toggling

ANALOG LOCK DETECT

Capacitance

On-chip capacitance; used to calculate RC time constant

for analog lock detect readback; use a pull-up resistor

REF1, REF2, AND VCO FREQUENCY STATUS MONITOR

Normal Range

1.02

MHz

Frequency above which the monitor indicates the

presence of the reference

Extended Range

kHz

Frequency above which the monitor indicates the

presence of the reference

LD PIN COMPARATOR

Trip Point

1.6

Hysteresis

260

AD9520-3/PCBZ 数据表(PDF) 15 Page - Analog Devices

AD9520-3/PCBZ 数据表(HTML) 15 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

数据表下载

链接网址

AD9520-3/PCBZ 数据表(PDF) 15 Page - Analog Devices

AD9520-3/PCBZ 数据表(HTML) 15 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

数据表 下载

链接网址

数据表下载