CS2300-CP_09 datasheet(17/32 Pages) CIRRUS

17 / 32 page

CS2300-CP

DS843F1

in either a high resolution (12.20) or high multiplication (20.12) format selectable by the LFRatioCfg bit,

with 20.12 being the default.

The RUD for high resolution (12.20) format is encoded with 12 MSBs representing the integer binary por-

tion with the remaining 20 LSBs representing the fractional binary portion. The maximum multiplication

factor is approximately 4096 with a resolution of 0.954 PPM in this configuration. See “Calculating the

User Defined Ratio” on page 29 for more information.

The RUD for high multiplication (20.12) format is encoded with 20 MSBs representing the integer binary

portion with the remaining 12 LSBs representing the fractional binary portion. In this configuration, the

maximum multiplication factor is approximately 1,048,575 with a resolution of 244 PPM. It is recommend-

ed that the 12.20 High-Resolution format be utilized whenever the desired ratio is less than 4096 since

the output frequency accuracy of the PLL is directly proportional to the accuracy of the timing reference

clock and the resolution of the RUD.

5.3.2

Ratio Modifier (R-Mod)

The Ratio Modifier is used to internally multiply/divide the RUD (the Ratio stored in the register space re-

mains unchanged). The available options for RMOD are summarized in Table 1 on page 17.

The R-Mod value selected by RModSel[2:0] is always used in the calculation for the Effective Ratio

(REFF), see “Effective Ratio (REFF)” on page 17. If R-Mod is not desired, RModSel[2:0] should be left at

its default value of ‘000’, which corresponds to an R-Mod value of 1, thereby effectively disabling the ratio

modifier.

Table 1. Ratio Modifier

5.3.3

Effective Ratio (REFF)

The Effective Ratio (REFF) is an internal calculation comprised of RUD and the appropriate modifiers, as

previously described. REFF is calculated as follows:

REFF = RUD

• R

MOD

Referenced Control

Ratio...................................... “Ratio (Address 06h - 09h)” on page 26

LFRatioCfg ............................ “Low-Frequency Ratio Configuration (LFRatioCfg)” on page 28

RModSel[2:0]

Ratio Modifier

000

001

010

011

100

0.5

101

0.25

110

0.125

111

0.0625

Referenced Control

Ratio...................................... “Ratio (Address 06h - 09h)” on page 26

RModSel[2:0] ........................ “R-Mod Selection (RModSel[2:0])” section on page 25

CS2300-CP 数据表(PDF) 17 Page - Cirrus Logic

CS2300-CP 数据表(HTML) 17 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

数据表下载