SPBT2532C2AT datasheet(30/48 Pages) STMICROELECTRONICS

30 / 48 page

Commands

SPBT2532C2.AT

30/48

Doc ID 16089 Rev 3

C.12.1

Syntax

AT+AB EnableBond

AT+AB EnableBond [BD addr]

AT+AB EnableBond [BD addr] [PIN]

AT+AB EnableBond [BD addr] [PIN] [timeout]

Where

[BD addr] is the BD Address of the remote device with which to bond, [PIN] is

the PIN code to use (up to 16 characters), and

[timeout] is the duration of the timeout in

seconds (1 to 14,400, in decimal).

C.12.2

Responses

If the operation is successful, the response is:

AT-AB BondEnabled

If bonding has been initiated by a remote device, the notification is:

AT-AB BondPending [BD addr]

where

[BD addr] is the BD address of the remote device that initiated the bonding.

If bonding has occurred, the notification is:

AT-AB BondOk [BD addr]

where

[BD addr] is the BD address of the remote device with successful bonding.

If bonding was initiated by a remote device but failed, the notification is

AT-AB BondFail

When the time limit for bonding has expired, the notification is

AT-AB BondDisabled

C.13

EraseBondTable

The EraseBondTable command is used to erase all of the bonded device entries. Single

devices cannot be erased with this command

C.13.1

Syntax

AT+AB EraseBondTable

C.13.2

Responses

If the operation is successful, the response is:

AT-AB BondTableErased

C.14

ExitPark

The

ExitPark command is used to switch a device from park mode to active mode.

SPBT2532C2AT 数据表(PDF) 30 Page - STMicroelectronics

SPBT2532C2AT 数据表(HTML) 30 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

数据表下载