SPBT2532C2AT datasheet(34/48 Pages) STMICROELECTRONICS

34 / 48 page

Commands

SPBT2532C2.AT

34/48

Doc ID 16089 Rev 3

C.23.1

Syntax

AT+AB RemoteCommand [Enable/Disable]

Where

[Enable/Disable] is an e or E character to enable this parameter and a d or D

character to disable it.

C.23.2

Responses

If the feature is successfully applied, the response is:

AT-AB RemoteCommand [Enabled/Disabled]

C.24

RemoteCmdDisconnect

The RemoteCmdDisconnect command is used to disconnect a remote command

connection. This command only applies to the server side of the link; the remote device.

The client or local device, if using the abSerial interface, should use a SPPDisconnect

command since it is not in Remote Command mode.

C.24.1

Syntax

AT+AB RemoteCmdDisconnect

C.24.2

Responses

If the operation is successful, the response is:

AT-AB RemoteCmdModeClosed

C.25

Reset

The Reset command is used to reset the abSerial interface. This is provided in the event

that a host application wants to perform a software reset for error recovery. There is a

response prior to reset to verify the command was received by the abSerial interface.

C.25.1

Syntax

AT+AB Reset

C.25.2

Responses

If the operation is successful, the response is:

AT-AB ResetPending

SPBT2532C2AT 数据表(PDF) 34 Page - STMicroelectronics

SPBT2532C2AT 数据表(HTML) 34 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

数据表下载

链接网址

SPBT2532C2AT 数据表(PDF) 34 Page - STMicroelectronics

SPBT2532C2AT 数据表(HTML) 34 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

数据表 下载

链接网址

数据表下载