PIC12F1822-ISLASHMF datasheet(96/398 Pages) MICROCHIP

96 / 398 page

PIC12F/LF1822/16F/LF1823

DS41413A-page 96

Preliminary

 2010 Microchip Technology Inc.

9.1.1

WAKE-UP USING INTERRUPTS

When global interrupts are disabled (GIE cleared) and

any interrupt source has both its interrupt enable bit

and interrupt flag bit set, one of the following will occur:

• If the interrupt occurs before the execution of a

SLEEP instruction

- SLEEP instruction will execute as a NOP.

- WDT and WDT prescaler will not be cleared

-TO bit of the STATUS register will not be set

-PD bit of the STATUS register will not be

cleared.

• If the interrupt occurs during or after the execu-

tion of a SLEEP instruction

- SLEEP instruction will be completely exe-

cuted

- Device will immediately wake-up from Sleep

- WDT and WDT prescaler will be cleared

-TO bit of the STATUS register will be set

-PD bit of the STATUS register will be cleared.

Even if the flag bits were checked before executing a

SLEEP instruction, it may be possible for flag bits to

become set before the SLEEP instruction completes. To

determine whether a SLEEP instruction executed, test

the PD bit. If the PD bit is set, the SLEEP instruction

was executed as a NOP.

FIGURE 9-1:

WAKE-UP FROM SLEEP THROUGH INTERRUPT

Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1

Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4

OSC1(1)

CLKOUT(2)

Interrupt flag

GIE bit

(INTCON reg.)

Instruction Flow

Instruction

Fetched

Instruction

Executed

PC + 1

PC + 2

Inst(PC) = Sleep

Inst(PC - 1)

Inst(PC + 1)

Sleep

Processor in

Sleep

Interrupt Latency(4)

Inst(PC + 2)

Inst(PC + 1)

Inst(0004h)

Inst(0005h)

Inst(0004h)

Dummy Cycle

PC + 2

0004h

0005h

Dummy Cycle

TOST(3)

PC + 2

Note

XT, HS or LP Oscillator mode assumed.

CLKOUT is not available in XT, HS, or LP Oscillator modes, but shown here for timing reference.

TOST = 1024 TOSC (drawing not to scale). This delay applies only to XT, HS or LP Oscillator modes.

GIE = 1 assumed. In this case after wake-up, the processor calls the ISR at 0004h. If GIE = 0, execution will continue in-line.

PIC12F1822-I/MF 数据表(PDF) 96 Page - Microchip Technology

PIC12F1822-I/MF 数据表(HTML) 96 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载

链接网址

PIC12F1822-I/MF 数据表(PDF) 96 Page - Microchip Technology

PIC12F1822-I/MF 数据表(HTML) 96 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表 下载

链接网址

数据表下载