ST10F276Z5 datasheet(100/239 Pages) STMICROELECTRONICS

100 / 239 page

I2C interface

ST10F276Z5

100/239

I2C interface

The integrated I2C Bus Module handles the transmission and reception of frames over the

two-line SDA/SCL in accordance with the I2C Bus specification. The I2C Module can

operate in slave mode, in master mode or in multi-master mode. It can receive and transmit

data using 7-bit or 10-bit addressing. Data can be transferred at speeds up to 400 Kbit/s

(both Standard and Fast I2C bus modes are supported).

The module can generate three different types of interrupt:

●

Requests related to bus events, like start or stop events, arbitration lost, etc.

●

Requests related to data transmission

●

Requests related to data reception

These requests are issued to the interrupt controller by three different lines, and identified as

Error, Transmit, and Receive interrupt lines.

When the I2C module is enabled by setting bit XI2CEN in XPERCON register, pins P4.4 and

P4.7 (where SCL and SDA are respectively mapped as alternate functions) are

automatically configured as bidirectional open-drain: the value of the external pull-up

resistor depends on the application. P4, DP4 and ODP4 cannot influence the pin

configuration.

When the I2C cell is disabled (clearing bit XI2CEN), P4.4 and P4.7 pins are standard I/ O

controlled by P4, DP4 and ODP4.

The speed of the I2C interface may be selected between Standard mode (0 to 100 kHz) and

Fast I2C mode (100 to 400 kHz).

ST10F276Z5 数据表(PDF) 100 Page - STMicroelectronics