| 数据搜索系统,热门电子元器件搜索 |
|
STE12PS 数据表(PDF) 22 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STE12PS 数据表(HTML) 22 Page - STMicroelectronics |
|
22 / 44 page ![]() Obsolete Product(s) - Obsolete Product(s) Functional description STE12PS 22/44 classification and powering. These measurements can be loaded into dedicated registers via the I2C bus and are intended to be averaged over time in order to maximize PSSR and noise rejection as well as minimize 50 to 60 Hz interference. 3.8 Power boost mode - 30W 3.8.1 Four channels in Auto mode When this mode is activated, the device will run the classification extending the IEEE classes with an extra PD_Class boost as detailed in Table 4. If class boost is detected, an equivalent double port (parallel of two channels) is switched-on allowing up to 30W of power to be supplied. All the other IEEE classes behave as a standard port (powering on one channel only). Table 5 below describes channel parallelism: Channels in boost mode behave as master or slave according to the above table. Detection and classification are performed only on the master ports. If a class 0 to 4 PD is detected, only MC is powered. Otherwise, if Boost Class is detected, both MC and the related SC are powered. Once powered, any fault condition (short circuit, over current, over power, PD disconnection) occurring either for MC or SC forces the reaction of both channels. All status and measurement information are stored in registers pertaining to the MC. Detection procedure is the same as the standard one while the classification phase is performed with 3 classification impulses (total classification time 70ms). 3.8.2 Six channels in Manual mode To activate this mode the device should be set with CH_NUMx ="00" and the Manual mode must be selected. Under these conditions the output channels can be shorted together as illustrated in Figure 9 and according to the following table. Table 5. Power boost mode: master/slave channel parallelism Master Channel (MC) Slave Channel (SC) 15 26 37 48 Table 6. Power boost mode: master/slave channel parallelism Master Channel (MC) Slave Channel (SC) 15 26 37 48 912 10 11 |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |