MB86604LPFV datasheet(2/56 Pages) FUJITSU

2 / 56 page

MB86604L

(Continued)

• Two types of high-speed data transfer:

– Synchronous data transfer (Max. 10 Mbytes/s, max. 32 offsets, 32-step transfer rate)

– Asynchronous data transfer (Max. 5 Mbyte/s)

• Transfer parameters (transfer mode, transfer rate, transfer offset) can be set for up to 7 connected devices.

• Single-ended transmission type (Maximum cable length: 6 m):

– On-chip single-ended driver/receiver which can drive 48 mA of "L" level output current

– Directly connectable with the SCSI bus

• On-chip three-state bidirectional I/O buffers for SCSI REQ and ACK pins (DB7-DB0, DBP, ATN, MSG, C/D, I/

O pins can be selected from either three-state or open-drain buffer by controlling the TEST pins input.)

Transfer Operation:

• Automatic response to selection/reselection (Preset receiving operation can perform at the selection/

reselection.):

– Initiator: Automatically operates until message received without command issue.

– Target: Automatically operates until command received without command issue.

• Automatic receiving:

– Initiator: Automatically receives information for new phase to which target transited without command issue.

– Target: Automatically receives message from initiator when initiator generates attention condition.

• On-chip 32-byte data register (FIFO) for data phase

• On-chip two (send-only and receive-only) 32-byte data buffers for message, command, and status phases

• On-chip 16-bit transfer block register and 24-bit transfer byte register enabling 1 Tbytes transfer (1 Tbytes: 16

Mbytes

× 64 k blocks)

• On-chip independent data transfer bus enabling the MPU operation during the data transfer

• Parity through/generate can be specified.

System Bus Interface:

• 8-bit or 16-bit separate MPU and DMA buses

• Directly connectable with a 80 series or 68 series MPU

• Two types of transfer operation:

– Program transfer

– DMA transfer (Burst/Handshake)

Command Set:

• Supports sequential commands and programmable commands in addition to ordinary commands

• Command queuing (Command can be continuously issued by putting tags to commands in command phase.)

• On-chip 256-byte memory for command programming memory and command queuing buffer

Others

• Process: CMOS process

• Supply Voltage: Single +5 V

• Input System Clock: 20 MHz/30 MHz/40 MHz

• Package: 100-pin plastic LQFP

MB86604LPFV 数据表(PDF) 2 Page - fujitsu semiconductor

MB86604LPFV 数据表(HTML) 2 Page - fujitsu semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

数据表下载