H7CX-R11W-N datasheet(33/56 Pages) OMRON

33 / 56 page

H7CX-A

@-N

Tachometer

Operation in Run Mode

Tachometer Operation

Bottom hold value

Peak hold value

Bottom hold value 1

Peak hold value 1

Bottom hold value 2

Peak hold value 2

Measurement value 1

Comparison value 1

Measurement value 2

Comparison value 2

Measurement value

• Set each digit using the individual

U Keys.

Displayed when the input mode is not 2 inputs.

• Measurement value

Displays the currently measured value.

• Comparison value 1/Comparison value 2

Set comparison value 1 and comparison value 2.

The measurement value is compared to

comparison value 1 and comparison value 2 and

output is made according to the selected output

mode.

*1 Measurement value 1 for the 2-input input mode.

*2 Measurement value 2 for the 2-input input mode.

*3 Peak/bottom hold enabled

Displayed for the 2-input input mode.

• Peak/bottom hold value

The peak (maximum) and bottom (minimum)

values are displayed after counting starts.

• Peak/bottom hold value 2

Peaks (maximums) 1 and 2 and bottoms

(minimums) 1 and 2 are displayed after counting

starts.

Note: The held values will be initialized when

the Reset Key (Hold Key) or reset 1 input

is turned OFF while peak/bottom hold

values 1 and 2 are being displayed. (The

reset 2 input operates in the same way if

the input mode is set to 2-input mode.)

H7CX-R11W-N 数据表(PDF) 33 Page - Omron Electronics LLC

H7CX-R11W-N 数据表(HTML) 33 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

数据表下载