H7CX-A

@-N

35

Switching between Preset Counter, Total and Preset Counter, Batch Counter, Dual

Counter, Twin Counter, and Tachometer Operation

Select which H7CX configuration is used (i.e., preset counter, total and preset counter, batch counter, dual counter, twin counter, or tachometer)

in configuration selection mode.

The H7CX is also equipped with a DIP switch monitor function, a convenient function that enables the settings of the DIP switch pins to be

confirmed using the display on the front of the H7CX.

Hold Function

The measurement value (display value) and output are sustained while the hold input is ON.

Note: The output will maintain the current status when the hold key is pressed.

Example:

Output mode

setting

Operation

Lower limit

1

+

1

1

RST

bcnt

dcnt

taco

twn

1cnt

2cnt

tcnt

Key

Key

Key

Key

…Indicates that DIP switch pin 8 is ON.

…Indicates that DIP switch pin 7 is OFF.

…Indicates that DIP switch pin 6 is ON.

…Indicates that DIP switch pin 5 is OFF.

…Indicates that DIP switch pin 4 is ON.

…Indicates that DIP switch pin 3 is OFF.

…Indicates that DIP switch pin 2 is ON.

…Indicates that DIP switch pin 1 is ON.

*The configurations that can be selected depend on the model.

Press the

key for 1 s

min.

*1 When the mode is changed to configuration selection mode, the present value is reset, outputs turn OFF, and counting (measuring) stops.

*2 Setting changes made in configuration selection mode are enabled when the mode is changed to run mode. If the configuration is changed, the

set value (or set value 1 and set value 2), comparison value 1 and comparison value 2 are initialized.

Power ON

Example

Configuration

selection

Note

DIP switch

monitor

(DIP)

Con

venient

*2

*1

*This display is possible only when DIP switch pin 1 (DIP switch settings enable/disable)

is set to ON (enable).

Select the configuration using the

UD Key.

1

1

To change the mode to configuration selection mode, hold

down the

Key for 1 s min. with the

Key held down.

The mode will not change if the

Key is pressed first.

(1-stage

preset

counter)

(2-stage

preset

counter)

(Total and

preset counter)

(Batch

counter)

(Dual

counter)

(Twin

counter)

(Tachometer)

Note: By default, the H7CX is set to the 1-stage preset counter configuration. (Two-stage

models are set to the 2-stage preset counter configuration.)

Confirm the status of DIP switch pins 1 to 8 using the

UD Key.

OFF

ON

12345678

OUT

Display value

Hold input* (Reset Key)

Comparison value (lower limit)

Sustained display value

Sustained output

Actual input