DS00002103A-page 27

USB3500

6.5

Reset Detection

If a device in HS mode detects bus inactivity for more than 3ms (T1), it reverts to FS mode. This enables the FS pull-up

on the DP line in an attempt to assert a continuous FS J state on the bus. The Link must then check LINESTATE for the

SE0 condition. If SE0 is asserted at time T2, then the upstream port is forcing the reset state to the device (i.e., a Driven

SE0). The device will then initiate the HS detection handshake protocol.

FIGURE 6-1:

RESET TIMING BEHAVIOR (HS MODE)

TABLE 6-5:

RESET TIMING VALUES (HS MODE)

Timing Parameter

Description

Value

HS Reset T0

Bus activity ceases, signaling either a reset or

a SUSPEND.

0 (reference)

T1

Earliest time at which the device may place

itself in FS mode after bus activity stops.

HS Reset T0 + 3. 0ms < T1 < HS Reset T0 +

3.125ms

T2

Link samples LINESTATE. If LINESTATE =

SE0, then the SE0 on the bus is due to a Reset

state. The device now enters the HS Detection

Handshake protocol.

T1 + 100µs < T2 <

T1 + 875µs