DS00002103A-page 33

USB3500

LINESTATE signals asserted continuously for 165 CLKOUT cycles.

6.11

Assertion of Resume

In this case, an event internal to the device initiates the resume process. A device with remote wake-up capability must

wait for at least 5ms after the bus is in the idle state before sending the remote wake-up resume signaling. This allows

the hubs to get into their suspend state and prepare for propagating resume signaling.

The device has 10ms where it can draw a non-suspend current before it must drive resume signaling. At the beginning

of this period the Link may negate SUSPENDN, allowing the transceiver (and its oscillator) to power up and stabilize.

Figure 6-7 illustrates the behavior of a device returning to HS mode after being suspended. At T4, a device that was

previously in FS mode would maintain TERMSELECT and XCVRSELECT high.

FIGURE 6-6:

HS DETECTION HANDSHAKE TIMING BEHAVIOR FROM SUSPEND

TABLE 6-9:

HS DETECTION HANDSHAKE TIMING VALUES FROM SUSPEND

Timing Parameter

Description

Value

T0

While in suspend state an SE0 is detected on the USB. HS

Handshake begins. D+ pull-up enabled, HS terminations

disabled, SUSPENDN negated.

0 (HS Reset T0)

T1

First transition of CLKOUT. CLKOUT “Usable” (frequency

accurate to ±10%, duty cycle accurate to 50±5).

T0 < T1 < T0 + 5.6ms

T2

Device asserts Chirp K on the bus.

T1 < T2 < T0 + 5.8ms

T3

Device removes Chirp K from the bus. (1 ms minimum width)

and begins looking for host chirps.

T2 + 1.0 ms < T3 <

T0 + 7.0 ms

T4

CLK “Nominal” (CLKOUT is frequency accurate to ±500 ppm,

duty cycle accurate to 50±5).

T1 < T3 < T0 + 20.0ms

CLK60

Look for host chirps

Device Chirp K

SUSPENDN

DP/DM

TERMSELECT

TXVALID

SE0

J

CLK power up time

XCVRSELECT

OPMODE 1

OPMODE 0

time

T0

T3

T4

T1

T2