CLC030 datasheet(14/29 Pages) NSC

14 / 29 page

Device Operation (Continued)

an internal pull down device, is mandatory to prevent admis-

sion of noise or unwanted signals at any time, especially

during power-up or reset sequences. It is strongly recom-

mended that VCLK not be applied until device initialization

and configuration is completed.

Example: Enable the TPG Mode to use the NTSC 270Mbps

colour bars as the BIST and TPG pattern. Enable TPG

operation using the I/O port.

Set ANC/CTRL to a logic-low.

Set RD/WR to a logic-low.

Present 00Dh to AD[9:0] as the TEST 0 register ad-

dress.

Toggle ACLK.

Present 303h to AD[9:0] as the register data (525 line,

30 frame, 27MHz, NTSC 4x3, colour bars (SMPTE

125M)).

Toggle ACLK.

Set TPG ENABLE (I/O Port, bit 7) to a logic-high.

Toggle ACLK.

The PASS/FAIL indicator (I/O Port, bit 6) is monitored

for the result of the test. Alternatively, the TEST 0 regis-

ter may be read. Bit 7 is the Pass/Fail indicator bit.

CONFIGURATION AND CONTROL REGISTERS

The configuration and control registers store data which

configures the operational modes of the CLC030 or which

result from its operation. Many of these registers may be

mapped to the multi-function I/O bus to make them available

as external I/O functions. These functions and initial values

are summarized in

Table 1 and detailed in Table 2. The

power-on default condition for the multi-function I/O port is

indicated in

Table 1 and detailed in Table 6.

CLC030 数据表(PDF) 14 Page - National Semiconductor (TI)