AT86RF211DAI-R datasheet(29/48 Pages) ATMEL

29 / 48 page

AT86RF211

1942C–WIRE–06/02

Control Register (CTRL2)

• Clock Recovery Function

The clock recovery function is activated by setting to ‘1’ the DATACLK bit of the CTRL1

The clock recovery function provides on DATACLK pin the data clock, synchronized on

the received data flow. The targeted position for the rising edge of the clock is the mid-

dle of the data bit. It is then easy for the microcontroller to read without synchro troubles.

Clock recovery mechanism is based on the generation of a basic data clock with a

period given by DATARATE of CTRL2 with a step of about 100 ns. This basic clock is

synchronized on the received data flow with a phase correction step fixed by DATATOL

of CTRL2 register (step of about 100 ns also).

So, DATATOL can

–

compensate for the difference between the read data rates from transmitter

and receiver (fixed by DATARATE).

–

allow fast initial synchronization of data clock, avoiding bit transition times

and converge toward the middle of the bit.

–

keep the right data rate (no additional and no removed bit) when a noisy

data with bad bit transition position arrives.

The best value of DATATOL is a trade-off between these considerations. The typical

recommended value of RATETOL is 2% of DATARATE.

Table 7. CTRL2 Overview

Name

DATARATE

DATATOL

LDCK

N0LD1

N1LD2

nbit

31-18

17-10

8-5

4-0

init

(0000)16

(00)16

(0010)2

(10111)2

Table 8. CTRL2 Detailed Description

Name

Number of

bits

Comments

DATARATE

Received DATAMSG rate

This value must be programmed to have the DATACLK activated.

(selected with DATACLK bit in CTRL1 register).

Value from 1 kbps to 50 kbps

reset value: (0000)

DATATOL

Tolerance for DATACLK, clock recovery

Recommended value = 2% of the rate.

reset value: (00)

LDCK

Clock frequency is doubled to increase precision of PLL lock detection

0: 10 MHz clock frequency

1: doubled clock frequency

reset value: 0

N0LD2

PLL unlock condition trigger

Recommended values are reset values

reset value: (0010)

N1LD2

PLL lock condition trigger

Recommended values are reset values

reset value: (10111)

AT86RF211DAI-R 数据表(PDF) 29 Page - ATMEL Corporation

AT86RF211DAI-R 数据表(HTML) 29 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

数据表下载