P89LPC901FD datasheet(2/55 Pages) PHILIPS

2 / 55 page

Philips Semiconductors

P89LPC901/902/903

8-bit microcontrollers with two-clock 80C51 core

Product data

Rev. 04 — 21 November 2003

2 of 55

9397 750 12293

s Serial Flash In-Circuit Programming (ICP) allows simple production coding with

commercial EPROM programmers. Flash security bits prevent reading of sensitive

application programs.

s Watchdog timer with separate on-chip oscillator, requiring no external

components. The watchdog prescaler is selectable from 8 values.

s Low voltage reset (Brownout detect) allows a graceful system shutdown when

power fails. May optionally be conﬁgured as an interrupt.

s Idle and two different Power-down reduced power modes. Improved wake-up from

Power-down mode (a low interrupt input starts execution). Typical Power-down

current is 1

µA (total Power-down with voltage comparators disabled).

s Active-LOW reset. On-chip power-on reset allows operation without external reset

components. A reset counter and reset glitch suppression circuitry prevent

spurious and incomplete resets. A software reset function is also available.

s Conﬁgurable on-chip oscillator with frequency range options selected by user

programmed Flash conﬁguration bits. Oscillator options support frequencies from

20 kHz to the maximum operating frequency of 12 MHz (P89LPC901).

s Watchdog timer with separate on-chip oscillator, requiring no external

components. The watchdog prescaler is selectable from 8 values.

s Programmable port output conﬁguration options: quasi-bidirectional, open drain,

push-pull, input-only.

s Port ‘input pattern match’ detect. Port 0 may generate an interrupt when the value

of the pins match or do not match a programmable pattern.

s LED drive capability (20 mA) on all port pins. A maximum limit is speciﬁed for the

entire chip.

s Controlled slew rate port outputs to reduce EMI. Outputs have approximately

10 ns minimum ramp times.

s Only power and ground connections are required to operate the

P89LPC901/902/903 when internal reset option is selected.

s Four interrupt priority levels.

s Two (P89LPC901), three (P89LPC903), or ﬁve (P89LPC902) keypad interrupt

inputs.

s Second data pointer.

s Schmitt trigger port inputs.

s Emulation support.

P89LPC901FD 数据表(PDF) 2 Page - NXP Semiconductors

P89LPC901FD 数据表(HTML) 2 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55

数据表下载