26

S29AL008D

S29AL008D_00A3 June 16, 2005

Da t a

S h ee t

Legend:

X = Don’t care, RA = Address of the memory location to be read, RD = Data read from location RA during read operation, and

PA = Address of the memory location to be programmed. Addresses latch on the falling edge of the WE# or CE# pulse, whichever

happens later. PD = Data to be programmed at location PA. Data latches on the rising edge of WE# or CE# pulse, whichever

happens first. SA = Address of the sector to be verified (in autoselect mode) or erased. Address bits A18–A12 uniquely select any

sector.

Notes:

1. See Table 1, on page 11 for a description of bus operations.

2. All values are in hexadecimal.

3. Except when reading array or autoselect data, all bus cycles are write operations.

4. Data bits DQ15–DQ8 are don’t cares for unlock and command cycles.

5. Address bits A18–A11 are don’t cares for unlock and command cycles, unless PA or SA required.

6. No unlock or command cycles required when reading array data.

7. The Reset command is required to return to reading array data when device is in the autoselect mode, or if DQ5

goes high (while the device is providing status data).

8. The fourth cycle of the autoselect command sequence is a read cycle.

9. The data is 00h for an unprotected sector and 01h for a protected sector. See Autoselect Command Sequence, on

page 20 for more information.

10.The Unlock Bypass command is required prior to the Unlock Bypass Program command.

11.The Unlock Bypass Reset command is required to return to reading array data when the device is in the unlock

bypass mode.

12.The system may read and program in non-erasing sectors, or enter the autoselect mode, when in the Erase Suspend

mode. The Erase Suspend command is valid only during a sector erase operation.

13.The Erase Resume command is valid only during the Erase Suspend mode.