ADC3561 datasheet(73/85 Pages) TI

73 / 85 page

9.3 Power Supply Recommendations

The ADC356x requires two different power-supplies. The AVDD rail provides power for the internal analog

circuits and the ADC itself while the IOVDD rail powers the digital interface and the internal digital circuits like

decimation filter or output interface mapper. Power sequencing is not required.

The AVDD power supply must be low noise in order to achieve data sheet performance. In applications

operating near DC, the 1/f noise contribution of the power supply needs to be considered as well. The ADC

is designed for very good PSRR which aides with the power supply filter design.

Frequency of Signal on AVDD (MHz)

0.05

0.1

100

D42_

Figure 9-7. Power supply rejection ratio (PSRR) vs frequency

There are two recommended power-supply architectures:

1. 1. Step down using high-efficiency switching converters, followed by a second stage of regulation using a

low noise LDO to provide switching noise reduction and improved voltage accuracy.

2. 2. Directly step down the final ADC supply voltage using high-efficiency switching converters. This approach

provides the best efficiency, but care must be taken to ensure switching noise is minimized to prevent

degraded ADC performance.

TI WEBENCH® Power Designer can be used to select and design the individual power-supply elements

needed: see the WEBENCH® Power Designer

Recommended switching regulators for the first stage include the TPS62821, and similar devices.

Recommended low dropout (LDO) linear regulators include the TPS7A4701, TPS7A90, LP5901, and similar

devices.

For the switch regulator only approach, the ripple filter must be designed with a notch frequency that aligns with

the switching ripple frequency of the DC/DC converter. Note the switching frequency reported from WEBENCH®

and design the EMI filter and capacitor combination to have the notch frequency centered as needed. Figure 9-8

and Figure 9-9 illustrate the two approaches.

AVDD and IOVDD supply voltages should not be shared in order to prevent digital switching noise from coupling

into the analog signal chain.

www.ti.com

ADC3561, ADC3562, ADC3563

SBAS990B – FEBRUARY 2021 – REVISED OCTOBER 2022

Submit Document Feedback

Product Folder Links: ADC3561 ADC3562 ADC3563

ADC3561 数据表(PDF) 73 Page - Texas Instruments

ADC3561 数据表(HTML) 73 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85

数据表下载