| 数据搜索系统,热门电子元器件搜索 |
|
AM29LV640MT110REF 数据表(PDF) 34 Page - Advanced Micro Devices |
|
|
|||||||||||||||||||||||||||||
AM29LV640MT110REF 数据表(HTML) 34 Page - Advanced Micro Devices |
|
34 / 66 page ![]() 32 Am29LV640MT/B 26190C8 February 1, 2007 D A TA SH EE T Figure 5. Program Operation Program Suspend/Program Resume Command Sequence The Program Suspend command allows the system to interrupt a programming operation or a Write to Buffer programming operation so that data can be read from any non-suspended sector. When the Program Sus- pend command is written during a programming pro- cess, the device halts the program operation within 15 μs maximum (5 μs typical) and updates the status bits. Addresses are not required when writing the Program Suspend command. After the programming operation has been sus- pended, the system can read array data from any non-suspended sector. The Program Suspend com- mand can also be issued during a programming oper- ation while an erase is suspended. In this case, data can be read from any addresses not in Erase Suspend or Program Suspend. If a read is needed from the Se- cured Silicon Sector area (One-time Program area), then user must use the proper command sequences to enter and exit this region. The system can also write the autoselect command sequence when the device is in the Program Suspend mode. The system can read as many autoselect codes as required. When the device exits the autoselect mode, the device reverts to the Program Suspend mode, and is ready for another valid operation. See Autoselect Command Sequence on page 28 for more information. After the Program Resume command is written, the device reverts to programming. The system can deter- mine the status of the program operation using the DQ7 or DQ6 status bits, just as in the standard pro- gram operation. See Write Operation Status on page 38 for more information. START Write Program Command Sequence Data Poll from System Verify Data? No Yes Last Address? No Yes Programming Completed Increment Address Embedded Program algorithm in progress Note: See Table 13 for program command sequence. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |