STM32F427AI datasheet(94/240 Pages) STMICROELECTRONICS

94 / 240 page

Electrical characteristics

STM32F427xx STM32F429xx

94/240

DS9405 Rev 12

2. VIN maximum value must always be respected. Refer to Table 15 for the values of the maximum allowed

injected current.

Table 15. Current characteristics

Symbol

Ratings

Max.

Unit

∑IVDD

Total current into sum of all VDD_x power lines (source)(1)

270

∑IVSS

Total current out of sum of all VSS_x ground lines (sink)(1)

− 270

IVDD

Maximum current into each VDD_x power line (source)(1)

100

IVSS

Maximum current out of each VSS_x ground line (sink)(1)

− 100

IIO

Output current sunk by any I/O and control pin

Output current sourced by any I/Os and control pin

− 25

∑IIO

Total output current sunk by sum of all I/O and control pins (2)

120

Total output current sourced by sum of all I/Os and control pins(2)

− 120

IINJ(PIN) (3)

Injected current on FT pins (4)

− 5/+0

Injected current on NRST and BOOT0 pins (4)

Injected current on TTa pins(5)

±5

∑IINJ(PIN)(5)

Total injected current (sum of all I/O and control pins)(6)

±25

1. All main power (VDD, VDDA) and ground (VSS, VSSA) pins must always be connected to the external power supply, in the

permitted range.

2. This current consumption must be correctly distributed over all I/Os and control pins. The total output current must not be

sunk/sourced between two consecutive power supply pins referring to high pin count LQFP packages.

3. Negative injection disturbs the analog performance of the device. See note in Section 6.3.21: 12-bit ADC characteristics.

4. Positive injection is not possible on these I/Os and does not occur for input voltages lower than the specified maximum

value.

5. A positive injection is induced by VIN>VDDA while a negative injection is induced by VIN<VSS. IINJ(PIN) must never be

exceeded. Refer to Table 14 for the values of the maximum allowed input voltage.

6. When several inputs are submitted to a current injection, the maximum

ΣIINJ(PIN) is the absolute sum of the positive and

negative injected currents (instantaneous values).

Table 16. Thermal characteristics

Symbol

Ratings

Value

Unit

TSTG

Storage temperature range

− 65 to +150

°C

Maximum junction temperature

125

°C

STM32F427AI 数据表(PDF) 94 Page - STMicroelectronics

STM32F427AI 数据表(HTML) 94 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载