CS2000-CP

DS761F1

31

8.5.2

Enable Device Configuration Registers 2 (EnDevCfg2)

This bit, in conjunction with EnDevCfg1, configures the device for control port mode. These EnDevCfg

bits can be set in any order and at any time during the control port access sequence, however they must

both be set before normal operation can occur.

Note:

EnDevCfg1 must also be set to enable control port mode. See “SPI / I²C Control Port” on

page 24.

8.6

Ratio 0 - 3 (Address 06h - 15h)

These registers contain the User Defined Ratios as shown in the “Register Quick Reference” section on

page 27. Each group of 4 registers forms a single 32-bit ratio value as shown above. See “Output to Input

Frequency Ratio Configuration” on page 19 and “Calculating the User Defined Ratio” on page 34 for more

details.

8.7

Function Configuration 1 (Address 16h)

8.7.1

Clock Skip Enable (ClkSkipEn)

This bit enables clock skipping mode for the PLL and allows the PLL to maintain lock even when the

CLK_IN has missing pulses.

Note:

EnDevCfg2

Register State

0

Disabled.

1

Enabled.

Application:

“SPI / I²C Control Port” on page 24

76543210

MSB

...................................................................................................................................................

MSB-7

MSB-8

...................................................................................................................................................

MSB-15

LSB+15

...................................................................................................................................................

LSB+8

LSB+7

...................................................................................................................................................

LSB

76543210

ClkSkipEn

AuxLockCfg

Reserved

RefClkDiv1

RefClkDiv0

Reserved

Reserved

Reserved

ClkSkipEn

PLL Clock Skipping Mode

0

Disabled.

1

Enabled.

Application:

“CLK_IN Skipping Mode” on page 15