 |
数据搜索系统，热门电子元器件搜索 |
|
|
数据搜索系统，热门电子元器件搜索 |
|
SST49LF040 数据表(PDF) 1 Page - Silicon Storage Technology, Inc |
|
|
|||||||||||||||||||||||||||||
SST49LF040 数据表(HTML) 1 Page - Silicon Storage Technology, Inc |
|
|
1 / 48 page  ©2001 Silicon Storage Technology, Inc. S71213-00-000 11/01 562 1 The SST logo and SuperFlash are registered trademarks of Silicon Storage Technology, Inc. Intel is a registered trademark of Intel Corporation. These specifications are subject to change without notice. Advance Information FEATURES: • LPC Interface Flash – SST49LF040: 512K x8 (4 Mbit) • Conforms to Intel LPC Interface Specification 1.0 • Flexible Erase Capability – Uniform 4 KByte sectors – Uniform 64 KByte overlay blocks – 64 KByte Top boot block protection – Chip-Erase for PP Mode Only • Single 3.0-3.6V Read and Write Operations • Superior Reliability – Endurance: 100,000 Cycles (typical) – Greater than 100 years Data Retention • Low Power Consumption – Active Read Current: 6 mA (typical) – Standby Current: 10 µA (typical) • Fast Sector-Erase/Byte-Program Operation – Sector-Erase Time: 18 ms (typical) – Block-Erase Time: 18 ms (typical) – Chip-Erase Time: 70 ms (typical) – Byte-Program Time: 14 µs (typical) – Chip Rewrite Time: 8 seconds (typical) – Single-pulse Program or Erase – Internal timing generation • Two Operational Modes – Low Pin Count (LPC) Interface mode for in-system operation – Parallel Programming (PP) mode for fast production programming • LPC Interface Mode – 5-signal communication interface supporting byte Read and Write – 33 MHz clock frequency operation – WP# and TBL# pins provide hardware write protect for entire chip and/or top boot block – Standard SDP Command Set – Data# Polling and Toggle Bit for End-of-Write detection – 5 GPI pins for system design flexibility – ID pins for multi-chip selection – Decode both top and bottom regions of the system memory map • Parallel Programming (PP) Mode – 11-pin multiplexed address and 8-pin data I/O interface – Supports fast programming In-System on pro- grammer equipment • CMOS and PCI I/O Compatibility • Packages Available – 32-lead PLCC – 32-lead TSOP (8mm x 14mm) PRODUCT DESCRIPTION The SST49LF040 flash memory devices are designed to interface with the LPC bus for PC and Internet Appliance application in compliance with Intel Low Pin Count (LPC) Interface Specification 1.0. Two interface modes are sup- ported by the SST49LF040: LPC mode for In-System operation and Parallel Programming (PP) mode to interface with programmer equipment. The SST49LF040 flash memory devices are manufactured with SST’s proprietary, high performance SuperFlash Tech- nology. The split-gate cell design and thick oxide tunneling injector attain better reliability and manufacturability com- pared with alternate approaches. The SST49LF040 device significantly improves performance and reliability, while low- ering power consumption. The SST49LF040 device writes (Program or Erase) with a single 3.0-3.6V power supply. It uses less energy during Erase and Program than alterna- tive flash memory technologies. The total energy con- sumed is a function of the applied voltage, current and time of application. Since for any give voltage range, the Super- Flash technology uses less current to program and has a shorter erase time, the total energy consumed during any Erase or Program operation is less than alternative flash memory technologies. The SST49LF040 product provides a maximum Byte-Program time of 20 µsec. The entire memory can be erased and programmed byte-by-byte typ- ically in 8 seconds when using status detection features such as Toggle Bit or Data# Polling to indicate the comple- tion of Program operation. The SuperFlash technology pro- vides fixed Erase and Program time, independent of the number of Erase/Program cycles that have performed. Therefore the system software or hardware does not have to be calibrated or correlated to the cumulative number of erase cycles as is necessary with alternative flash memory technologies, whose Erase and Program time increase with accumulated Erase/Program cycles. To meet high density, surface mount requirements, the SST49LF040 device is offered in 32-lead TSOP and 32- lead PLCC packages. See Figures 2 and 3 for pin assign- ments and Table 1 for pin descriptions. 4 Mbit LPC Flash SST49LF040 SST49LF0404 Mb LPC Flash |
类似零件编号 - SST49LF040 |
|
类似说明 - SST49LF040 |
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Chinese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
