AS0260CSSC28SUD20 datasheet(9/83 Pages) ONSEMI

9 / 83 page

AS0260 DS Rev. G Pub. 5/15 EN

©Semiconductor Components Industries, LLC, 2015.

AS0260: 1/6-Inch 1080P High-Definition (HD) System-On-A-Chip (SOC) Digi-

tal Image Sensor

1. AGND and DGND are not connected internally.

2. To be left floating if not using feature.

3. Must always be connected even when not using MIPI.

4. The VDD, REG_OUT, and REG_FB pins must be connected together and have a 0.1F

decoupling capacitor attached.

Table 1:

Pin Descriptions

Name

Type

Description

Note

EXTCLK

Input

Input clock signal.

RESET_BAR

Input/PU

Master reset signal, active LOW. This signal has an internal pull up.

SCLK

Input

Two-wire serial interface clock.

SDATA

I/O

Two-wire serial interface data.

SADDR

Input

Selects device address for the two-wire serial interface.

FRAME_VALID (FV)

Output

Identifies rows in the active image.

LINE_VALID (LV)

Output

Identifies pixels in the active line.

PIXCLK

Output

Pixel clock.

DOUT[7:0]

Output

DOUT[7:0] for 8-bit image data output or DOUT[9:2] for 10-bit image data

output.

CLK_N

Output

Differential MIPI clock (sub-LVDS, negative).

CLK_P

Output

Differential MIPI clock (sub-LVDS, positive).

DATA_N

Output

Differential MIPI data (sub-LVDS, negative).

DATA_P

Output

Differential MIPI data (sub-LVDS, positive).

DATA_2N

Output

Differential MIPI data (sub-LVDS, negative).

DATA_2P

Output

Differential MIPI data (sub-LVDS, positive).

CONFIG/GPIO1

Input/Output

If on power-up CONFIG =1 then the part shall go into streaming else the

system will go to suspend state waiting for host to update. This pin can

also be re-programmed to support multiple functions.

CHAIN/GPIO0

Input/Output

To synchronize a number of sensors together. This pin can also be re-

programmed to support multiple functions.

GPIO2

Input/Output

General purpose input/output.

SHUTDOWN

Input

Low power shutdown control, active HIGH.

TRST_BAR

Input

Must be tied to GND in normal operation.

VDD

Supply

Digital power. Must connect to REG_OUT and REG_FB.

DGND

Supply

Digital ground.

VDD_IO

Supply

I/O power supply.

VAA

Supply

Analog power.

VAA_PIX

Supply

Analog pixel power.

AGND

Supply

Analog ground.

VPP

Supply

OTPM programming.

REG_IN0

Supply

Digital power

REG_OUT

Supply

Digital power. Must connect to VDD and REG_FB.

REG_FB

Supply

Digital power. Must connect to VDD and REG_OUT.

VDD_PHY

Supply

I/O power supply for the MIPI interface.

AS0260CSSC28SUD20 数据表(PDF) 9 Page - ON Semiconductor

AS0260CSSC28SUD20 数据表(HTML) 9 Page - ON Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83

数据表下载

链接网址

AS0260CSSC28SUD20 数据表(PDF) 9 Page - ON Semiconductor

AS0260CSSC28SUD20 数据表(HTML) 9 Page - ON Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83

数据表 下载

链接网址

数据表下载