ST92185B datasheet(57/178 Pages) STMICROELECTRONICS

57 / 178 page

57/178

ST92185B - RESET AND CLOCK CONTROL UNIT (RCCU)

4 RESET AND CLOCK CONTROL UNIT (RCCU)

4.1 INTRODUCTION

The Reset Control Unit comprises two distinct sec-

tions:

– An oscillator that uses an external quartz crystal.

– The Reset/Stop Manager, which detects and

flags Hardware, Software and Watchdog gener-

ated resets.

4.2 RESET / STOP MANAGER

The RESET/STOP Manager resets the device

when one of the three following triggering events

occurs:

– A hardware reset, consequence of a low level on

the RESET pin.

– A software reset, consequence of an HALT in-

struction when enabled.

– A Watchdog end of count.

The RESET input is schmitt triggered.

Note: The memorized Internal Reset (called RE-

SETO) will be maintained active for a duration of

32768 Oscin periods (about 8 ms for a 4 MHz crys-

tal) after the external input is released (set high).

This RESETO internal Reset signal is output on

the I/O port bit P3.7 (active low) during the whole

reset phase until the P3.7 configuration is changed

by software. The true internal reset (to all macro-

cells) will only be released 511 Reference clock

periods after the Memorized Internal reset is re-

leased.

It is possible to know which was the last RESET

triggering event, by reading bits 5 and 6 of register

SDRATH.

Figure 29. Reset Overview

Build-up Counter

RCCU

True

RESET

RESETO

Memorized

Reset

Internal

Reset

ST92185B 数据表(PDF) 57 Page - STMicroelectronics

ST92185B 数据表(HTML) 57 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载