| 数据搜索系统,热门电子元器件搜索 |
|
ST7MC1K2 数据表(PDF) 219 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
ST7MC1K2 数据表(HTML) 219 Page - STMicroelectronics |
|
219 / 371 page ![]() Obsolete Product(s) - Obsolete Product(s) ST7MC1K2-Auto, ST7MC1K6-Auto, ST7MC2S4-Auto, ST7MC2S6-Auto On-chip peripherals 219/371 shifted left (multiplied by two). The RMI bit in the MISR register is set and an interrupt is generated if RIM is set. – If the prescaler contents reach the value 0, it can no longer be automatically decremented, the MTC continues working with the same prescaler value, that is, with a lower accuracy. No RMI interrupt can be generated. – If the prescaler contents reach the value 15, it can no longer be automatically incremented. When the timer reaches the value FFh, the prescaler and all the relevant registers remain unchanged and no interrupt is generated, the timer restarts counting from 0 x 00h and if the TES[1:0] bits = 00, the OI bit in the MCRC register is set at each overflow (it has to be reset by software). The RPI bit is no longer set. The PWM is still generated and the D and Z detection circuitry still work, enabling the capture of the maximum timer value. The automatically updated registers are: MTIM, MZREG, MZPRV, MCOMP and MDREG. Access to these registers is summarized in Table 99. Debug option In both switched mode and autoswitched mode, setting the bit DG in MPWME register enables the debug option. This option consists of outputting the C, D and Z signals in real time on pins MCZEM and MCDEM. This is very useful during the debug phase of the application. Figure 95 shows the signals output on pins MCDEM and MCZEM with the debug option. Note: 1 When the delay coefficient equals 0/256 (C event immediately after Z event), a glitch appears on MCZEM pin to be able to see the event even in this case. This option is also available in speed measurement mode with different signal outputs (see Figure 95): ● MCDEM toggles when a capture event is generated. ● MCZEM toggles every time a U event is generated. These signals are only available if the TES[1:0] bits = 10, 01 or 11. 2 In sensor mode, the MCDEM output pin toggles at each C event. The MCZEM pin outputs the Z event. Obsolete Product(s) - Obsolete Product(s) |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |