ST72321R7-Auto datasheet(103/243 Pages) STMICROELECTRONICS

103 / 243 page

ST72321xx-Auto

16-bit timer

Doc ID 13829 Rev 1

103/243

13.3.3

Input capture

In this section, the index, i, may be 1 or 2 because there are two input capture functions in

the 16-bit timer.

The two 16-bit input capture registers (IC1R and IC2R) are used to latch the value of the

free running counter after a transition is detected on the ICAPi pin (see Figure 46).

ICiR register is a read-only register.

The active transition is software programmable through the IEDGi bit of Control Registers

(CRi).

Timing resolution is one count of the free running counter: (fCPU/CC[1:0]).

Procedure:

To use the input capture function select the following in the CR2 register:

●

Select the timer clock (CC[1:0]) (see Table 61: Timer clock selection).

●

Select the edge of the active transition on the ICAP2 pin with the IEDG2 bit (the ICAP2

pin must be configured as floating input or input with pull-up without interrupt if this

configuration is available).

And select the following in the CR1 register:

●

Set the ICIE bit to generate an interrupt after an input capture coming from either the

ICAP1 pin or the ICAP2 pin

●

Select the edge of the active transition on the ICAP1 pin with the IEDG1 bit (the

ICAP1pin must be configured as floating input or input with pull-up without interrupt if

this configuration is available).

When an input capture occurs:

●

ICFi bit is set.

●

The ICiR register contains the value of the free running counter on the active transition

on the ICAPi pin (see Figure 47).

●

A timer interrupt is generated if the ICIE bit is set and the I bit is cleared in the CC

Clearing the input capture interrupt request (that is, clearing the ICFi bit) is done in two

steps:

Reading the SR register while the ICFi bit is set

An access (read or write) to the ICiLR register

Note:

After reading the ICiHR register, transfer of input capture data is inhibited and ICFi will never

be set until the ICiLR register is also read.

The ICiR register contains the free running counter value which corresponds to the most

recent input capture.

The two input capture functions can be used together even if the timer also uses the two

output compare functions.

In One pulse Mode and PWM mode only Input Capture 2 can be used.

MS Byte

LS Byte

ICiR

ICiHR

ICiLR

ST72321R7-Auto 数据表(PDF) 103 Page - STMicroelectronics

ST72321R7-Auto 数据表(HTML) 103 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载