DOC4106 datasheet(22/47 Pages) ATMEL

22 / 47 page

AT8xC51SND1C

4106F–8051–10/02

Peripherals

Clock Generator System

The AT8xC51SND1C internal clocks are extracted from an on-chip PLL fed by an on-

chip oscillator. Four clocks are generated respectively for the C51 core, the MP3

decoder, the audio interface, and the other peripherals. The C51 and peripheral clocks

are derived from the oscillator clock. The MP3 decoder clock is generated by dividing

the PLL output clock. The audio interface sample rates are also obtained by dividing the

PLL output clock.

Ports

The AT8xC51SND1C implement five 8-bit ports (P0 - P4) and one 4-bit port (P5). In

addition to performing general-purpose I/Os, some ports are capable of external data

memory operations; others allow for alternate functions. All I/O Ports are bi-directional.

Each Port contains a latch, an output driver and an input buffer. Port 0 and Port 2 output

drivers and input buffers facilitate external memory operations. Some Port 1, Port 3 and

Port 4 pins serve for both general-purpose I/Os and alternate functions.

Timers/Counters

The AT8xC51SND1C implement the two general-purpose, 16-bit Timers/Counters of a

standard C51. They are identified as Timer 0, Timer 1, and can independently be config-

ured each to operate in a variety of modes as a Timer or as an event Counter. When

operating as a Timer, a Timer/Counter runs for a programmed length of time, then

issues an interrupt request. When operating as a Counter, a Timer/Counter counts neg-

ative transitions on an external pin. After a preset number of counts, the Counter issues

an interrupt request.

Watchdog Timer

The AT8xC51SND1C implement a hardware Watchdog Timer that automatically resets

the chip if it is allowed to time out. The WDT provides a means of recovering from rou-

tines that do not complete successfully due to software or hardware malfunctions.

MP3 Decoder

The AT8xC51SND1C implements a MPEG I/II audio layer 3 decoder (MP3 decoder).

In MPEG I (ISO 11172-3) three layers of compression have been standardized support-

ing three sampling frequencies: 48, 44.1, and 32 kHz. Among these layers, layer 3

allows highest compression rate of about 12:1 while still maintaining CD audio quality.

For example, 3 minutes of CD audio (16-bit PCM, 44.1 kHz) data, which needs about

32M bytes of storage, can be encoded into only 2.7 MBytes of MPEG I audio layer 3

data.

In MPEG II (ISO 13818-3), three additional sampling frequencies: 24, 22.05, and 16 kHz

are supported for low bit rates applications.

The AT8xC51SND1C can decode in real-time the MPEG I audio layer 3 encoded data

into a PCM audio data, and also supports MPEG II audio layer 3 additional frequencies.

Additional features are supported by the AT8xC51SND1C MP3 decoder such as vol-

ume, bass, medium, and treble controls, bass boost effect and ancillary data extraction.

Audio Output Interface

The AT8xC51SND1C implements an audio output interface allowing the decoded audio

bitstream to be output in various formats. It is compatible with right and left justification

PCM and I

2S formats and the on-chip PLL (see Section “Clock Generator System”)

allows connection of almost all of the commercial audio DAC families available on the

market.

DOC4106 数据表(PDF) 22 Page - ATMEL Corporation

DOC4106 数据表(HTML) 22 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47

数据表下载