GD25S512MDBJS datasheet(56/87 Pages) GIGADEVICE

56 / 87 page

3.3V Uniform Sector

Dual and Quad Serial Flash

GD25S512MD

Enable Reset

Yes

Reset allowed anytime.

Reset

Yes

Reset allowed anytime.

The Program/Erase Suspend command will be accepted by the device only if the SUS2/SUS1 bit in the Status

SUS2/SUS1 bit equal to 1 or WIP bit equal to 0, the Suspend command will be ignored by the device. The WIP bit will be

cleared fro

m 1 to 0 within “tsus” and the SUS2/SUS1 bit will be set from 0 to 1 immediately after Program/Erase Suspend.

A power-off during the suspend period will reset the device and release the suspend state.

Figure 60 Program/Erase Suspend Sequence Diagram

7.34.

Program/Erase Resume (PER) (7AH)

The Program/Erase Resume command must be written to resume the program or sector/block erase operation after

a Program/Erase Suspend command. The Program/Erase Resume command will be accepted by the device only if the

SUS2/SUS1 bit equal to 1 and the WIP bit equal to 0. After issued the SUS2/SUS1 bit in the status register will be cleared

from 1 to 0 immediately, the WIP bit will be set from 0 to 1 within 200ns and the Sector or Block will complete the erase

operation or the page will complete the program operation. The Program/Erase Resume command will be ignored unless a

Program/Erase Suspend is active.

Figure 61 Program/Erase Resume Sequence Diagram

Command

75H

CS#

SCLK

High-Z

tSUS

Accept read command

Command

7AH

CS#

SCLK

Resume Erase/Program

GD25S512MDBJS 数据表(PDF) 56 Page - GigaDevice Semiconductor (Beijing) Inc.

GD25S512MDBJS 数据表(HTML) 56 Page - GigaDevice Semiconductor (Beijing) Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87

数据表下载