CC2430-RTR1-F64Z datasheet(192/234 Pages) TI

192 / 234 page

CC2430

CC2430 PRELIMINARY Data Sheet (rev. 1.03) SWRS036A

Page 192 of 232

Write instruction to

RFST

All instructions

written?

Setup CSPT, CSPX,

CSPY, CSPZ and

CSPCTRL registers

Start execution by

writing ISSTART to

RFST

yes

SSTOP instruction,

end of program or

writing ISTOP to

RFST stops program

Figure 56: Running a CSP program

14.34.7 Instruction Set Summary

This section gives an overview of the

instruction set. This is intended as a

summary and definition of instruction

opcodes. Refer to section 14.34.8 for a

description of each instruction.

Each instruction consists of one byte

which is written to the RFST register to be

stored in the instruction memory.

The Immediate Strobe instructions (ISxxx)

are not used in a program. When these

instructions are written to the RFST

the CSP is already executing a program

the current instruction will be delayed until

the Immediate Strobe instruction has

completed.

For undefined opcodes, the behavior of

the CSP is defined as a No Operation

Strobe Command (SNOP).

CC2430-RTR1-F64Z 数据表(PDF) 192 Page - Texas Instruments

CC2430-RTR1-F64Z 数据表(HTML) 192 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载