| 数据搜索系统,热门电子元器件搜索 |
|
FT800Q-R 数据表(PDF) 27 Page - Bridgetek Pte Ltd. |
|
|
|||||||||||||||||||||||||||||
FT800Q-R 数据表(HTML) 27 Page - Bridgetek Pte Ltd. |
|
27 / 46 page ![]() Copyright © Bridgetek Pte Ltd 27 FT800 Embedded Video Engine Datasheet Version 1.4 Document No.: BRT_000039 Clearance No.: BRT#001 4.8.3 Power Modes When supply to VCCIO and VCC is applied, internal 1.2V regulator is powered by VCC. An internal POR pulse will be generated during the regulator power up until it is stable. After the initial power up, the FT800 will stay in STANDBY state. When needed, host can set FT800 to ACTIVE state by performing a dummy read to address 0. The graphics engine, the audio engine and the touch engine are only functional in ACTIVE state. To save power host can send command to put FT800 into any of the low power mode: STANDBY, SLEEP and POWERDOWN. In addition, host is allowed to put FT800 in POWERDOWN mode by drive PD_N pin to low, regardless what current state it is in. Refer to Figure 4-9 Power State Transition for the power state transitions. Figure 4-9 Power State Transition 4.8.3.1 ACTIVE state In ACTIVE state, the FT800 is in normal operation. The crystal oscillator and PLL are functioning. The system clock applied to the FT800 core engines is enabled. 4.8.3.2 STANDBY state In STANDBY state, the crystal oscillator and PLL remain functioning; the system clock applied to the FT800 core engines is disabled. All register contents are retained. 4.8.3.3 SLEEP state In SLEEP state, the crystal oscillator, PLL and system clock applied to the FT800 core engines are disabled. All register contents are retained. 4.8.3.4 POWERDOWN state In POWERDOWN state, the internal 1.2V regulator supplying the core digital logic, the crystal oscillator, the PLL and the system clock applied to the FT800 core is disabled. All register contents are lost and reset to default when the chip is next switched on. POWERDOWN STANDBY SLEEP VCC/VCCIO Power ON Toggle PD_N from high to low ACTIVE Toggle PD_N from low to high Toggle PD_N from high to low Toggle PD_N from high to low or Write command “POWERDOWN” Write command “SLEEP” Write command “STANDBY” Dummy Read “0” Dummy Read “0” |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |