TDA4VL...ALZQ1 datasheet(235/251 Pages) TI

235 / 251 page

• Propagation delays and matching:

– A to B = E to F = (C to D) / 2

– Matching skew: < 60 ps

Note

The OSPI Board Loopback Hold time requirement (described in OSPI) is larger than the Hold

time provided by a typical flash device. Therefore, the length of MCU_OPSI[x]_LBCLKO pin to the

MCU_OSPI[x]_DQS pin (C to D) can be shortened to compensate.

MCU_OSPI[x]_CLK

OSPI/QSPI/SPI

Device Clock Input

OSPI/QSPI/SPI

Device IO[y], CS#

MCU_OSPI[x]_D[y],

MCU_OSPI[x]_CSn[z]

MCU_OSPI_Board_02

MCU_OSPI[x]_LBCLKO

MCU_OSPI[x]_DQS

OSPI Device DQS

* 0 Ω resistor (R1), located as close as possible to the MCU_OSPI[x]_CLK and MCU_OSPI[x]_LBCLKO pins, is a placeholder for fine

tuning, if needed.

Figure 8-2. OSPI Interface High Level Schematic

8.2.2.3 DQS (only available in Octal Flash devices)

• The MCU_OSPI[x]_CLK output signal must be connected to the CLK pin of the flash device

• The DQS pin of the flash devices must be connected to MCU_OSPI[x]_DQS signal

• The signal propagation delay from the MCU_OSPI[x]_CLK pin to the flash device CLK input pin (A to B)

should be approximately equal to the signal propagation delay from the MCU_OSPI[x]_DQS pin to the DQS

output pin (C to D)

• 50 Ω PCB routing is recommended along with series terminations, as shown in Figure 8-3

• Propagation delays and matching:

www.ti.com

TDA4VE-Q1, TDA4AL-Q1, TDA4VL-Q1

SPRSP62 – DECEMBER 2022

Submit Document Feedback

235

Product Folder Links: TDA4VE-Q1 TDA4AL-Q1 TDA4VL-Q1

TDA4VL...ALZQ1 数据表(PDF) 235 Page - Texas Instruments

TDA4VL...ALZQ1 数据表(HTML) 235 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载