| 数据搜索系统,热门电子元器件搜索 |
|
KSZ9563RNXI-TR 数据表(PDF) 54 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
KSZ9563RNXI-TR 数据表(HTML) 54 Page - Microchip Technology |
|
54 / 226 page ![]() KSZ9563R DS00002419D-page 54 2017-2018 Microchip Technology Inc. 4.9.3 MII MANAGEMENT (MIIM) INTERFACE The device supports the IEEE 802.3 MII management interface, also known as the management data input/output (MDIO) interface. This interface allows upper-layer devices to monitor and control the states of the KSZ9563R PHY blocks, but it does not provide access to the switch registers. An external device with MDC/MDIO capability can read the PHY status or configure the PHY settings. Details on the MIIM interface can be found in Clauses 22 and 45 of the IEEE 802.3 Specification. Use of MIIM conflicts with use of the In-Band Management interface. These interfaces cannot be used simultaneously. The MIIM interface consists of the following: • A physical connection that uses a data signal (MDIO) and a clock signal (MDC) for communication between an external controller and the KSZ9563R. Note that the MDIO signal is open-drain. • A specific protocol that operates across the two signal physical connection that allows an external controller to communicate with the internal PHY devices. • Access to a set of standard, vendor-specific and extended (MMD) 16-bit registers. These registers are also directly accessible via the SPI and I2C interface options. The MIIM Interface can operate up to a maximum clock speed of 5MHz. Access is limited to only the registers in the PHY blocks of ports 1 and 2. Table 4-25 summarizes the MII management interface frame format. The MIIM PHY address to PHY port mapping is as follows: • PHY Address 1h to PHY port 1 • PHY Address 2h to PHY port 2 The MIIM register address space consists of two distinct areas. • Standard MIIM Registers (Direct) • MDIO Manageable Device (MMD) Registers (Indirect) FIGURE 4-15: BURST REGISTER WRITE FIGURE 4-16: BURST REGISTER READ TABLE 4-25: MII MANAGEMENT INTERFACE FRAME FORMAT Operation Mode Preamble (32-bit) Start of Frame (2-bit) Operation Code (2-bit) PHY Address (5-bit) Register Address (5-bit) Turn Around (2-bit) Register Data (16-bit) Idle Read All 1s 01 10 A[4:0] Reg[4:0] Z0 D[15:0] Z Write All 1s 01 01 A[4:0] Reg[4:0] 10 D[15:0] Z |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |